I have a Lanier LP226cn printer that has a service call error of SC545. What does this mean and can I override it?

Are these new or refilled?

Ricoh Error Code SC541 sc542 sc 543 sc544 sc545 sc546 Lanier Savin...

Here's a movie that show you how to fix it:

Ricoh Error Code SC541 sc542 sc 543 sc544 sc545 sc546 Lanier Savin...

thermal fuse blown this guy says


Ricoh Error Code SC541 sc542 sc 543 sc544 sc545 sc546 Lanier Savin...

Its a fuser Temp error. Check the thermistors on the fuser make sure they are good

Sorry, You do not need Black toner, you need a Black PCU (Photo Conductor Unit).
I have this same printer with the same warning.
Unfortunately, This unit seems to be rather expensive.
Good Luck

It's a fuser warm up error. Can only be reset in service mode by a technician after problem is repaired.

I have a lanier LD122 - error code is sc541

Hold the up and down arrows together for 10 seconds, and press ok. Select 2, for engine. Scroll to 7 or data log, press ok. Scroll to 7807, press ok, execute, exit all the way back to engine, and select 3 to end. Turn printer off and on. Try it. It is a fuser code, and it just might be dirty where the sensor touches.

That crosses over to the Lanier LP226cn.

SC307 - Charge AC bias error [Y] (Level D Error)**

Symptom: The charge current less than 200 ìA is detected.

Possible Causes / Required Actions:
• Defective charge roller
• Defective connectors
• Disconnected harness
• Defective high voltage power 1
1. Check the connectors.
2. Replace the PCU for yellow.
3. Replace the drum positioning plate.
4. Replace the high voltage power 1.

** (Level D Reset Procedure) Turning the main switch off then on resets SCs displayed on the operation panel. These are redisplayed if the error occurs again.

- Lanier Tech