Set up I need to get to the set up to enter code 001

I believe it can be changed. Type question into Google.

I am a tech that services Sharps.
Enter simulation mode using # * c * after you are in run test command 66-10 This problem happens from you getting a bad fax mostly from noise or interference to the line. if it happens a lot to you then try getting a power filter with network and fax ports.

I’m happy to help further over the phone at https://www.6ya.com/expert/ethan_e84416e0b13809d2

Enter the service mode (Press "Additional Function" key, Press "2" and "8" simultaneously, press "Additional Function" key again).
Go to COPIER----FUNCTIONS-----CLEAR----ERR. Here you can reset all error codes on by one.
If you will need more help you can get the service manual for the copier from the below link:
http://goo.gl/qVZLO
Good luck

You got to go to the phone setting, then scroll dowm to security click onto this enter your current security code, it will give options, if you to change your lock code click onto that and when it asks you for your new code enter it, it may ask you twice just enter it twicw and you now have installed a new lock for your phone, and you took the old lock off too.

1. Prior to setting up port forwarding in your router, you must manually enter an IP address into the Nintendo 3DS Internet settings.
2. Use your router settings to forward the ports 9103, and 50000 through 60000, to the IP address you provided your Nintendo 3DS system.

for more help visit CBR Tech Solutions

Programming is done on M7310, M7324 and T7316 sets.
To set up ringing you need to enter programming by pressing the feature key followed by **266344. When prompted to enter the password enter 266344.
The screen should say TERMINALS&SETS. The 4 top line/feature keys are now used for programming.
At the terminals&sets prompt,
press the show key (top right arrow).
The display should now ask for an extension number. Enter extension number you wish to program ringing on.
Press the show key (top right arrow)
The display should sat LINE ACCESS
Press the show key (top right arrow) .
The display should say LINE ASSIGNMENT.
Press the show key (top right arrow) .
The display ask for a line number. press list
The display should say line 001: appear only
press the Chng key till it says appear & ring
press next key (lower right arrow)
The display should say line 002: appear only
repeat the procedure the same as line 001 for the remaining ringing lines

press the release key when finished

Programming is done on M7310, M7324 and T7316 sets.
To set up ringing you need to enter programming by pressing the feature key followed by **266344.When prompted to enter the password enter 266344.
The screen should say TERMINALS&SETS. The 4 top line/feature keys are now used for programming.
At the terminals&sets prompt, press the show key (top right arrow). The display should now ask for an extension number. Enter extension number you wish to program ringing on. Press the show key (top right arrow)
The display should sat LINE ACCESS
Press the show key (top right arrow) .
The display should say LINE ASSIGNMENT.
Press the show key (top right arrow) .
The display ask for a line number. press list
The display should say line 001: appear & ring
press the Chng key till it says appear only press next key (lower right arrow)
The display should say line 002: appear & ring
repeat the procedure the same as line 001 for the remaining ringing lines

press the release key when finished

Sp 1-902-001 set to 0. Let me know if this helps. -Carl

Hello sir; Just follow my direction, it will reset your machine;
1, press "clear mode", "107", then press and hold down "clear/stop" key.
2, touch "copier SP" on the screen.
3, enter "5810-001" press enter.
4, set value to 0, then turn power off and back on again.