How do I clear my router - 2wire (1000-400108-001) Router

Try pushing the button for 10 seconds or more, because 5 seconds would be for wps or emergency firmware reload(like for a corrupted firmware).

Any router should work with any modem. Make sure you are running an ethernet cable from the WAN/Uplink port of the router to the modem, or in some cases it will be a USB cable. Also you can test your internet connection by plugging a computer directly into the modem.

Hello,

To clear out the problem if Network Magic has something to do with your connection.

1) Uninstall Network Magic from host computer.

2) Remove Ethernet connections to router.

3) Reset the router (press & hold reset button for at least 15 secs.)

4) Run Setup wizard on host computer and follow on screen instructions on connecting PC to router.

5) Setup wizard prompts on installing Network Magic, just ignore it.

6) if it automatically installs Network Magic just uninstall the program before you fully use your router.


Resetting router clears all settings made by Network Magic application made on the router.

Hope this helps.

On the back of the router is a reset button. This button has two (2 functions:

1. Reboot. When pressed and released, the Wireless Router will reboot (restart).

2. Clear All Data. This button can also be used to clear ALL Data and restore ALL settings to the factory default values:

To Clear ALL Data and restore the factory default values:

1. Power Off.
2. Hold the Reset Button down while you Power On.
3. Keep holding the Reset Button for a few seconds, until the RED LED has flashed TWICE.
4. Release the Reset Button. The Wireless Router is now using the Factory default values.

Hope that helps!

Check your connections. 1. Wired: directly connected to the modem (not the router) If this works, the router is the issue. 2. Wired directly to the router If this works then wireless is the problem 3. Wireless Check Key for accuracy, Upper and lower case matters. Check that your router does not have MAC address restrictions 4. Clear the cache on the laptop IE. Use the Options menu to clear this.

I would suggest rebooting the whole router. Clear out the settings completely and start again. To clear the router on the back or the router there is a tiny reset button. You will need to use a paperclip hold the button down for 5 sec then run through the setup disk again it should accept you new password this time.
Good Luck
Proteus

* there are 2 different types of reset one is hard reset and the other soft one * the hard reset u need a paper clip press the reset hole for more than one minute -- u need to feel the click when u press the reset hole --- if not then the reset button is not functioning * the soft reset is u need to login inside router using 192.168.2.1 in the address bar of ur browser and click on restore factory settings which is under UTILITIES on the left side * if still doesnt work u need to update the firmware in belkin.com/support

This page will guide you. Just choose the appropriate program for which you want the port to be forwarded. The link is:

http://portforward.com/english/routers/port_forwarding/Zonet/ZSR0104CP/ZSR0104CPindex.htm

Hello,
There are a few things can make your wireless router to lose your connection. I like to start with the most simple things first. First clear Out any clutter on your browser. If your are using Internet explorer, go to tools click delete browsing history. When the box appears, clear out the first 3 things. History, Cookies, and temporary Internet files. Firefox, you click on tools, clear private internet files.
After than do a disk cleanup.
In start menu, go to all programs, accessories,system tools and select disk clean up. After this unplug Cable modem's electric cord, unplug the power to your wireless router, leave it unplugged for a couple of minutes, Then plug in your modem,router and restart your pc in that order. If that doesn't work you can always change you network name and WEP key, Hope this helps, also I was assuming you are using a PC and not Mac.