How do you set up messages on mitel superset 4025

The time has to be changed in the programming interface of the phone system itself. You cannot change the time from any set other than a 4150 or a super console 1000. These sets can only be used to change the time on a mitel sx200 or icp. This does not work on the 3300.

Try to restart the phone. Unplug it for 10 minute and then start it normally...
try this and let me know

it's because the operator set a message to your phone. You need to leave the handset on the cradle and push the message button. Read the display and follow the prompts. You should be able to clear the message.

Either your on-Site system administrator, or your vendor will have to make the change. This is a system wide setting, not just your phone.

Hi,
Visit to the given link and download the manual... this manual contents the information required by you...
http://www.retrevo.com/support/Mitel-4025-Telephones-manual/id/3040ci572/t/2/
Hope this has helped you... Thanks...

You should contact your vendor for this support.

Here is the manual it is all explained in it. Link below. edocs.mitel.com/UG/EN/2ICP_4025_UG_R2_EN.pdf

That just means there is a call me back message. If you push messages and clear the ones you have then the light will stop blinking.

Need to log into phone system or if the 4150 is a sub att. you go through the softkeys.

You will need the Mitel system programmer to change the Class Of Service of your set, this will change the number of rings before it goes to Voicemail.

Unfortunately, unless you know how to get into the system or have an administrator onsite that has rights to the Mitel system, a Mitel Specialist will be required to make this change.