Lexicon lambda no sound during playback

All it needs is a USB connection. You'll need to go into Cubase device setup and make sure your lambda drivers are selected. Then create the audio channels in cubase with the inputs set as the inputs you're using for guitar and mic. There is a monitor button right next to the record enable button that needs to be enabled if you want to hear playback from your computer.

Good luck!

You'd be better directing your uestion here

http://www.lexicon.com/support/index.asp

You sucks man !

one of several install steps (the steps seem to vary depending on which manual you can find) mention checking your sound device setup in control panel. ON one machine I installed the sound devices were not affeted. On a 2nd PC they were changed from drivers installed with PC to the Lambda driver

Win XP settings->control panel->Sounds and Audio Devices then select Audio tab. Make sure the three areas are set up to use your PC's default drivers and not lambda's.

You may need to verify this again when reconnecting the Lambda USB cable. Sort of new but ran into this "issue" as well.

Found info in Lambda Studio Software Installation Guide I downloaded, step B following driver install.

playback from the lexicon. Disable winamp as default player

I have had the same problems with the lambda driver ...they just posted a new installer on the lexicon website which fixed me up...try it.

It's because when you recording your get sound from Lambda!!! But PC can't reproduce that quality! Try to download driver or update which will allow you to achieve what you want.

you need to go to the "control panel" on your computer.....click on sounds and audio devices, then hit the "audio" tab...make sure the lambda is selected on the recording and playback device....then apply...this should take care of it

push the monitor button to go mono instead of stereo.