R225M earpiece problem

If this is a bluetooth connection ,make sure its switched on in the phone and put a jack lead without buds into earphone piece on phone.

Most likely the 3.5mm jack is damaged or the earpiece receiver itself. Try it on different devices. If it only happen on your Nokia, the frequency may not be calibrated easily

There is a possibility that your earphones need cleaning. Take off the tips and gently brush the metallic mesh with some cloth. Then dip each earpiece into drop of alcohol (you need to dip mesh only, not the whole earpiece). Then wipe it clean with cotton bud or something similar. Next, dip your earpieces the same way into drop of hydrogen peroxide and leave them there for few minutes. After that, wipe them again.
I used this method on my ie8 and it really helped.

Hi, what makes oneofthe earphones not to work,is because the wire inside the right side of the earphone hascut and will need to soldered back to it's position.

Open the right side of the earphone,and use a soldering iron and a lead to put back the wire properly.
after put back the wire,problem solved.

Thanks for using fixya..

The cords are sealed into the earphone. You can take a multimeter and test the continutity of the either earpieces, once you are convinced that the left side is faulty, first of all use a small thin needle as the probe, use your multimeter in the continuity range, holding one end of the meter probe to the jack , inset the pin like an ijection into the wires to obtain the connection, it there is no connection out of the headphone jack, I think you can replace with a new one to be soldered. If not proceed to the earpiece to confirm, then open the sealed unit and be lucky if the earpiece is not damaged but only the wires. Good Day

Some people have reported that this error comes up when they have changed a lens on the camera, If the previous lens was IS enabled and was switched on when the old lens was attached, re attach the previous lens and switch off before attaching the new lens.
If this does not work, clean the contacts with a cotton bud dipped in methylated spirits. Hold the lens above you when doing this so nothing falls into the lens.

Just connect the pre existing speaker or earpiece through a newly installed E.P. socket.Whenever headset is connected to the E.P. socket, internal speaker will be disabled and external will be enabled. Same you have to do in the case of mic.Some more details are given below.
1.E.P. Socket = Earphone Socket ( With Series Switch, A SPDT switch is already attached to the inner side of the socket, whenever an E.P. Pin / Plug is inserted into the socket, It changes the position of the SPDT switch).
2.The inner speaker / earpiece / mic should be connected through the N/C ( Normally Connected ) Contact of the socket.

That is at your local dealer... LG will give you 1year warranty.. Anyways it seems to be a problem with the earphones.. Did you try a different set of earphones?

have you tried using differnt earphones? if the problem is still the same with different earphones then it's the ipod itself that has a problem, you'll have to get it fixed.

i have that problem too. using the speakerphone will help but calls arent clear..