My 26" lcd flm-2601 polaroid tv has been great however yesterday it made a popping sound like a breaker had blow or maybe a plug needed to be reset after that the tv went off and will not come back on at all. we have checked all of the breakers the plugs and everything works just not the tv. any suggestions. I have tried unplugging it from the unit and wall and to try and reset it as the manual says but thats not working. any advice would be great. thanks melissa

Buy one that can support the weight of the TV.

Power supply board is dead.Replaced the power supply board.Tries websites Shopjimmy.com,Ebay.com to buy a refurbish power supply board for the replacement.

First of all, check your input source on your TV.
Turn on TV.
Press the Input button on your remote.
Make sure the Source Input matches the corresponding device that is wired on the back of the TV.

need code for flm 2601 to program direct tv remote

The reset button on TVs is a thing of the past. The small pop you heard was very likely a part blowing up, probably a capacitor. They are under lots of stress because manufacturers use parts that run very close to their maximum ratings (lower cost that way) and sometimes they just can't handle it. Without seeing the set I can't tell you any specific part to check, but it will probably be in the power supply. A service shop could check it out and give an estimate for repair, or you could open the set yourself and look for obviously popped parts.

Pretty good chance the power supply board is bad. A number of capacitors will become leaky and you lose all power. Some techs still know how to do component Laval service but most just change the board $$$$

First off replacing the caps is not easy even for a tech. Double surface boards are soldered on both sides. The caps have a value printed on them like 1000@63 They also have polarity " they have to be put in in a certain direction" If you do something wrong you blow the works. Best to have it done by a tech.

The part number is 6LM00220G0 and is priced at $80.54 at circuit city repair. It is easy to install once you remove the cover from the back of the TV and the housing for the power supply.

Try Vance Baldwin a parts dist in florida

the handle Polaroid tv's

Needs a power supply - - MLT166A only available at Fox International..
Bill