Dear sir/mam im having a philips comfort juicer/blender of model no HR 1720,can u please suggest whre i will get a small pot whch wl get attached in this model?for your kind information model HR 2000/70 will also get attached to this model. thanking you paramita

my problem is E6 code & 1 or 2 minutes automate stopping

you can get a replacement sprayer with hose at lowes or sutherlands and change out the bad one.

You did not specify a brand or model number of your blender; however, most blender jars will lift off their power base without turning or with only very little turning motion to release them from the base. The blade assembly should NOT come off as you remove the blender jar from the power base.

Were you successful in removing the bottom ring which normally screws on to the bottom of the blender jar from the powerbase?

You should make sure you have properly attached the blade assembly for your brand/model.

The blender blade assembly should be held on to the bottom of the blender jar by the bottom ring which screws on clockwise; most will have a sealing gasket that fits between the blade assembly and the sealing surface of the blender jar to prevent any leakage while in use. It will take much more turning to unscrew the bottom ring to release the blade assembly than it should to release the bottom ring from the powerbase.

Assemble your blender jar and blade assembly and try a dry run by placing on the powerbase, giving a couple of bursts of power, and then seeing if you are able to remove without the blender ring unscrewing.

Make sure you are comfortable with the action required to remove the blender jar from the powerbase before you put in to use.

Good luck!

You can get the manual on the link below. Under add to bag you will see a tab saying product manual click on that then click on product manual.

http://kitchen-dining.hsn.com/wolfgang-puck-3-in-1-blender-food-processor-and-juicer_p-6046925_xp.aspx

I have the same problem now its the second time it got stuck. The manuals say not much. :(

Most major manufacturers supply manuals online so if you were to log on to the manufacturer's web site, you may be pleasantly surprised as usually, if available, one is able to download, by model number, Dealer Network for spare part supplies as required.

The information is normally free of charge.

Follow this LINK.

Just a suggestion: look underneath - there may be 2 prongs that you have to press together to push out, rather than having to unscrew it.

Try using a warm to hot cloth over area that is sealed. Do not submerge in water if this area of juicer has electrical components. If it doesn't have electrical components in this are, then hold upside down in sink with small amount of hot water covering sealed area of top. before removing from water, make sure u have a towel handy to set it on, dry with towel before flipping upright. try removing seal/top then. Hope this helps.

not normaly,,its all or nothing,,,its a money spinner!