Lazer 30 error 22 on panel - Rinnai Toyostove Direct Vent Heater: Laser 30 Toyostove Direct Vent Heater Shipping

https://www.youtube.com/watch?v=Vse_sK8LPXc

Samsung top-load washer error codes

• 1E. Water level sensor failure. Check/ ...
• 3E. Drive motor or hall sensor (tachometer) error. ...
• nF or nF1. Water supply error. ...
• nD. Won't drain. ...
• AE. Communication error between the main electronic control board and the display control in the control panel. ...
• E2. Stuck button. ...
• DS, FL or LO. Lid lock/switch failure. ...
• HE1. Heating element failure.

https://www.searspartsdirect.com/diy/error-codes/washer-repair/1234598/samsung-top-load-washer/1482
Switch off the power to the appliance, wait 30 seconds then Switch the power supply back on. The drain pump should operate to drain the washing machine. If problem persists please call the customer support team. Switch off the appliance at the mains then wait 30 seconds.May 22, 2019
https://www.samsung.com/levant/support/home-appliances/washing-machine-what-does-the-error-code-means-and-how-to-fix-it/

Could be a dirty Lazer or a dying one. Use a cotten swab damped with eye glass cleaner and gently clean the Lazer eye. If problem consist then your Lazer might be dying.

Hey I'm using a HP LASERJET M1120 MFP. But every time I turn on the machine the screen says "Scanner Error 20". How to fix it up? Thanks!

maybe the spindle motor is turning defect causing not to spin the disc naturally,its time to have to check that to the Toshiba service center

Hi,
    First you didn't mention model number which helps to find out the cause of fault, Secondly the ERROR you show is wrong according to service manual. Please check it again it could be ERROR C:31:22 but not C:30:22 and it is for T reel fault which means that the problem is in machenical section which removes from mechanical adjustment. For this contact any expert nearby to you for MECHANICAL ADJUSTMENT.
Thanks for using FIXYA!

EE22 is a lockout code.
Unplug unit for 30 min.
You need to findout why you still get EE2 or EE6
Check fuel and filter
Still have problems call me I'm in North Pole
Dave 4889179

Hi

The title of your post suggests that you have "Maga RAID" errors. Maga RAID messages would be in line with issues on the LSI PERC sub-system.

However, the extract posted in your suggests network problems.

Any number of physical to driver and configuration issues can result in network problems.

Try the basic checks;
1. Change or try a known patch cable
2. Run "ping" test to a known good system connected to same network switch or direct connect with a "cross-over" cable and check for dropped connections.
3. Is the NIC and switch set to Auto-Negotiation or static at 10, 100 or 1000Mbps speed
4. Can you try another switch
5. Check and load correct or latest manufacture's drivers

Reply with more info.

Mike

EE-22 means that the unit has tried three times to ignite. after this it goes into a "lockout" condition. remove the power and the computer will reset itself. it will then try to re-ignite. check for a fuel blockage, dirty filter etc. if there's water in your kerosene it will not fire! kerosene floats on top of water. bleed your system until you get kero and no water. use a gas additive to remove water. dry-gas will work. just empty the bottle's contents into your tank. on your computer type in toyostove error codes. this will take you to toyo's site and explains the error codes.