My washer/dryer will not fill with water - Hotpoint Aquarius WD63 Front Load Washer/Dryer

I would check the lid switch 1st

Could be the circuit board at fault

I think the control board is at fault

first access the tech sheet and run any diagnostics it shows for the machine and if this passes,then check/change the fill switch on the control panel along with fill tube from the wash tub base if kinked or plugged

check the fill valve and the connections to it the problem probly lies inthere. the valve is located inside the machine where you water hooks up.

my washer fills up with water but will not drain

Try the valves inside the back where the water hoses connect to the machine they should default to the closed position when water is not required

check the water pressure switch

well i am having about the same problem, but mine won't even fill, the dryer works but the washer won't fill or turn on at all. my husband had it all apart, too the control assembly to parts place and they said that hardly ever goes bad so it is still sitting unusable with no answer or money to spend on it in site.

Have suffered the same problem. Suggest you remove back (after turning off electrical supply) and look at the water outlet pipe - you may have a sock or two in this - remember to reattach outlet and secure in position.