It has colors all over kinda like if u were watching a 3d movie how do i fix this or will resetting the tv help if so how do i do it

the tv automaticly determines if it should go to 3D mode as long as the DVD player or say like PS3 or PS4 is connected to HDMI (yes those two game consoles will support HD Blueray 3D and DVD 3D movies) if the TV isnt displaying 3D look into the video settings of your TV to enable that ability also your TV will come with 3D glasses if the TV supports 3D

Since a 3d movie takes way more bandwidth then a normal movie but have. you also tried it at night when all neighbours are sleeping

May be problem on setting .Please program again or setting multisystems.your tv picture ntsc you should change pal

Do you have the PTA02 accessory for the TV? This is a USB 3D transmitter and comes with 2 pairs of Active 3D glasses. The screen of the 40PFL8605H is not a 3D TV by itself.

Once you have the accessory plugged in, you may need to wait for the software to be installed on your TV before you can watch 3D content. See the manual for the TV for more information: http://download.p4c.philips.com/files/4/40pfl8605h_12/40pfl8605h_12_dfu_eng.pdf . This is on page 73 of the PDF.

I hope this helps. If you have the 3D accessory plugged in, try turning off the TV and turning it back on if the software did not install properly. The final thing to check is the "codecs" for your 3D movies on the USB stick. Make sure that they are compatible with the TV.

Cindy Wells

The tv have a problems known as a convergence pictures problems.Tv have any colors lines R,G,B mis alignments,tv have any colors shadows pictures or have a 3D pictures look alike?Yes,than the tv convergence board it is the causes and already dead to have many of these convergence pictures problems.The tv convergence board must have to be repair like replacing 2 STK convergence ICS and some or all of it resistors too.To fixed the tv convergence board to solved the tv convergence pictures many problems.The tvs shops will cost u like $300-$350 for parts and labors.

Unfortunately, there is no way you can do this without making some adjustments to either the movie clip or to your TV.
These adjustments could eventually end up in making the 3D movie more or less a normal HD movie.
The best way is to buy a 3D TV and glasses. This would help you watch the movie in 3D.

3D in tv technology wright now are in it infincy.Not worth the money to buy the 3D LED tv and it 3D external devices.Right now are very limited in productions in movies in 3D world or 3D movies for tv or transfer from 3D movies from the movies theather Big Screen.Right now,just best to watch 3D movies in the theather Big Screen.Stick to a 2 dementional LCD tv screen for at lest another 5 years,before there are 3D tvs and movies,will make a difference in ur lives.

This is a common problem that was NOT caused by watching the 3D movie! Bad solder connections on the high voltage transformer have caused a solder in fuse to blow. The transformer will have to be resoldered and the fuse replaced.

This is a convergence problem and is either bad connections on the convergence ICs or defective ICs. If you feel that you can solder, you should be able to repair this yourself. First try resoldering the pins on the convergence ICs. If that fails, replace the ICs. These ICs are large black ICs attached to a heatsink and should be marked STKxxx.
Keep us posted.
Dan

convergence IC.s replacement and realigment job for expert technician no to expensive job