I need a freq band chart for galaxy v radio - Galaxy Radios DX-99V 40-Channels Base CB Radio

so,what numbers does it show? If you are at 27.187 or 27.183 it should be no problem that little amount of frequency differance won't make any differance. Now if you were at 27.180 or 190 then you would be going into another band width.

Here is a link to a channel chart and band switch setting.
Galaxy Radios DX73V Service Manual

• Here is a link to the frequency chart for the Conexx 3300 http://i1236.photobucket.com/albums/ff442/Ironfist109/freqchart.jpg

• This site does not allow a big enough spot to upload a diagram that would be beneficial for this purpose so I had to upload it off site. Since this radio is often converted to run on 11 meter (CB frequencies) the diagram I uploaded corresponds with the frequencies after conversion.

• On the Connex radio's the band "HI/LOW" switch determine the band you are on in relation to the knob. If you want the original, stock, frequency chart let me know and I can put that up as well.

• If you have any comments please feel free to leave them here.
• Hope this helps and thank you for using FixYa.

Regards, Tony

Hello,
It sounds like your crystal has gone bad. More than likely it is the 10.25 crystal. Unfortunately if you have no Oscilloscope then you need to take it to a radio tech as you have to inject a frequency into the triple band to get the radio to Oscillate again, once the crystal is replaced.
Regards, Tony

To use this radio on the CB band, you set the 10 Khz switch to OFF, and then turn the band switch to A/E.

Here is a Frequency Chart.
Here is the manual.

When the 10 Khz switch is on OFF, the band switch is E,F,G,H. When the 10 Khz switch is in the ON position, then the band switch is A,B,C,D.

So when you are on band E, which is when the 10 Khz is OFF, and the band switch is in the first position, it is on the E band.

I would get your self a Frequency counter. It makes using a radio like that much easier.

Hope this helps!

Without looking at it and from what you're saying a crystal went bad in the radio.A crystal is what controls your channels or freq.

high band and D will give you channel 19 freq. 27.185.

depending on what channel your talking on..go on line and print yourself out a freq. chart

sounds to me someone was tampering with it ,your best bet is to get a frequency counter and realine the radio .start from 27.185 centre band you can do this by tuning the ossolator be very careful not to damage this should realine the radio for you goodluck

That is wrong , I used to have a freq. counter that only read when you applied RF to it on my old Tempo rig and I ran lower 37 and upper 35 so I would key the radio on am and tune the vfo to that frequency and would be on frequency with everone else,I remember hearing that once long ago but it's not true.