SOURCE: 900 Service RIP software error
a 900 rip error is the engine card. located behind the system board (formatter) if you can get the printer to a ready state you can phone 1800lexmark and get a pin code from them costs about 15 bucks. if this flash does not work you will likley need a new engine card.
SOURCE: 900 service RIP software error on boot-up
removed memory off the system board restarted printer. came up to an error no memory found.
powered down and reinstalled memory on board in a different slot and restarted unit...
NO ERRORS......
SOURCE: 900.80 Service RIP Software
This error can be resolved by clearing the print cue for that printer at the print server if its a network printer. If this is a local print just do the same at the computer, clear all documents that is in the cue for print and that should cover you:)
SOURCE: lexmark T520 I get an error code 900 service RIP
Typically the engine controller circuit cards go bad. the firmware (software) get corrupted. you can try upgrading the firmware but ordinarly you cant clear the 900 service fault to try that. So your only solution is the replace the engine circuit card.
POR the printer. If the error message persists,
replace the system card. Partnumber: 40X4219
1,108 views
Usually answered in minutes!
×