Eclipse CD5405 Logo

Related Topics:

Question about Eclipse CD5405

1 Answer

My CD5405 has gone into a security lockout since battery maintenance. How do I clear lockout.

Posted by mfay450334 on

1 Answer


  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,932 Answers

Canceling or unlocking the security feature is done by a KEY CD. When you got the player you might have registered a KEY CD with your player. Please insert that key CD and OK will appear in display and CD will start playing .This will unlock the player.

If you don’t have this CD please contact you eclipse dealer and they will rest the full system and will unlock it.

Thank You

Posted on Sep 07, 2010

Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:


2001 Grand Prix. How do I clear tehe anti-theft security lockout?

The system only activates like this if there is a defect in the systems operation, you must have the security system scanned to see what is causing the unwanted activation. This is a dealer level repair.

Stereo lock up

how long have you had this problem

How do I properly reset my ecu?

Without knowing the vehicle, can't say for certain. But most cars, for "proper" cleaning of ECM/ECU codes, requires the use of a scantool that plugs into the diagnostic socket. Some cars can be cleared with other methods, including battery disconnects, but these can pose other issues with respect to radio lockouts and immobilizer security systems.

All instrutments gages go dead until you disconnect battery then it gos back to normal

Without any further information, this problem hints of a security lockout. It also suggests a loose or corroded wire connector, possibly at the PCM, or the security module, if the security module is separate from the PCM.

Sebring code from dash p1698

clear code. dissconnect from battery power for 10 minutes. reconnect. Check to make sure you regounded the wiring harness if you removed any grounds during the tranny removal. If the code or problem persist go see dealer.

I have a 2001 grand am it starts and shuts off?

Sounds like you may have a security lockout. Try the relearn procedure.


Time required, approximately 10 minutes:

1. Insure that the battery is fully charged.
2. Use the scan tool in order to clear the DTCs.
3. Turn the ignition switch from the OFF position to the CRANK position attempting to start the vehicle. The vehicle will start and then stall.
4. Leave the ignition switch in the ON position while observing the security indicator.
5. When the security indicator turns off, which can take up to 10 minutes, turn the ignition switch off. Wait 10 seconds.
6. The BCM and the PCM will learn the new code on the next start attempt.


Although rebranded, the OEM battery for most Japanese motorcycles is Yuasa. There are some maintenance free batteries for MCs now available. Maintenance free batteries do not have the clear plastic PVC hose lines. Batteries last about 4 years... when in doubt, replace it. Check your battery either under the seat or accessible from the plastic side fairing to see if it has a hose nipple on the battery. If it doesn't then the battery is a maintenance free type. If it has a hose nipple, buy a new clear plastic PVC hose from a service station (usually used for car windshield washers) or (better) pet shop (used for aquariums) and run a length down the frame until its clear of metal so the battery water can drip onto the pavement. Cable ties work great at securing it as you don't want the liquid dripping on anything except the ground.

How do I reset the radio

look for 4 digit security code in owners/maintenance books enter into have 3 attempts before lockout. if this occurs disconnect battery again

Power windows aren't working


Thanks for using FixYa. Please check all the window switches, window lockout relays, window lockout switches, window motors, window regulators and window tracks and replace whichever is gone bad. Also check that the wire connections of all the switches are fine. There are prongs and there should never be battery voltage at all prongs or the switch is bad.

Please do accept the solution if the issue is resolved or else revert for further assistance.



Setting the clock on Eclipse cd5405 deck

Push the function button once. turn the right knob (SEL) untill CLOCK ADJ shows on the screen. push SEL in one time to lock in CLOCK ADJ and the hours will blink. Turn the SEL knob to set the hours. push SEL again to get to the min. Turn SEL again to set min.
Not finding what you are looking for?


Ask a Question

Usually answered in minutes!

Top Eclipse Car Audio & Video Experts

The Knight
The Knight

Level 3 Expert

76851 Answers

xxxxxx xxx

Level 3 Expert

5061 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1198 Answers

Are you an Eclipse Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides