Hi My name is peter, how do you take the screen apart , I got the 4 screews out please

Hello;

My name is Peter. I am a retired field service appliance technician.


There are two spring clips, one on each side of the bottom toe plate panel.

hi, please clean the printer lsu(laser scaner unit).its located under the printer ,you taken the papper tray & look the lsu is fixing the 3 screew please remoove the screew & connecter cable & then clean the lasu mirror & moter

HI I HAVE THE SAME MACHINE AND MY FEED ROLLERS HAVE JAMMED SO AN EXPLODED DIAGRAM MIGHT BE HANDY AS I PULL IT APART
COULD YOU PLEASE EMAIL ME A COPY OF IT TO
PETER BULLARD AT [email protected]
THANKS PETER

#1. how did ink get every where
#2. i am the maker of epson please refer to the manual

screews at bottem and 2 on back. be carefull because if you dismantle it, it's warenty will be un valid

try <ctrl -> to decrease; <ctrl+> to increase

There are two screews onder the shield. You need to get level with the shield to see them. Remove the two screews and it should come off no problem. Now to get in to the controll panel you have to pull the oven out and there are two screews on the back in both top corners to get in side to the control board. Good luck

Hi Remove the spark plug,fan housing and chain cover.Enter in the spark plug hole a piston blockator (a rope with many nods) and block the piston in the cilinder.Remove the clutch clockwise and the flyweel counter clockwise.Remove the air filter,the cover,the mufller,the carburator,the handle,the gas and oil tanks.Locate the 4 screews to remove the cilinder .Remove the oiler and the worm gear.At the clutch side are the screws to separate the crankcase.
best regards savumihai71

hi peter
try here for them see if this is the right one Download WinFast Tv Tuner WinFast TV2000XP Expert 5.13.1.1309 Driver for Windows 95/98/9X/ME/NT/2000/2K/XP/2003 - Softpedia


riz.

HI fllow the step plz. open the uper body > open 4 screew > pick the protection plate > u see a jeck of display > plz open with carefully > place a new display > push the jeck tightly > place the protiton plate > put the screew > tight carefully > place the body. keep voteing THANKS.

See my other post. its very easy to replace the mechanism. Theres a printboard that seems to be hard to remove, but beware, you only need to remove the screews that holds the brassboard, and all the cables. Then You have acces to the Mec, wich only needs four screews to remove and thats it. Should only need half an our or so.

Good luck. Niels Peter - Denmark

PS Actually You can disable the automatic standby. Read the manual, cant remember the procedure.