Jensen vm 9412

Hello smcdon,

I'd go directly to Jensen. If the cable was defective when you purchased it, it should be replaced under warranty.

Here's the link to Jensen's web site.

Hope this helps.

you need the jensen jlink cable its about $25 and the code is 012345 i had the same problem and that code works

The newer generation iPods don't always work with the iPod connection kits in a lot of the car stereos. Some of the problem is due to the fact that the new generation iPods have been changed and the stereos were manufactured before the players were released so they are not compatible.
I bought my girlfriend a Pioneer car stereo with an iPod control cable, and it works fine with her Nano (not the new generation Nano) and it works with my iPod Photo 60 GB but it does not work with my iPhone 2G and I read that it is not compatible with the new Nanos or the Classics. Check with Jensen to see if the model you have is compatible with the Classic and see if there is a solution to the issue. It may not be compatible with the new video portion of the Classic firmware.

Cheers

All I can tell through my searching, is that the Jlink only works on gen3-gen5 ipods. I have a gen 6 80gb classic, and while I can hear the audio from the movie playing, I have no video. Music plays fine.

Download here: VM9412

tengo el mismo poblema

how can I restar a stereo car jensen vm9412

The new ipod will not work with anything other than 2008 alpine products. Apple embedded a chip in the actual cable that tells the ipod that it's ok to pay. What you need is an authentic apple video cable that can only be purchased at the apple store...then hook the inputs up to the video input on the radio.

You might need the jenson media module,that might have came with it.Mine did and I bought it 2nd hand.and a special ipod cable that hooks from the media module to your ipod.

Does yours give of a static noise coming from the speakers?