Casio Triple Sensor ATC-1200 Module #1170 I cannot find a manual for this old, but very complex, watch anywhere

You can download the manual from the link below. The timekeeping instructions are found on pages E-19 - E-24

http://support.casio.com/en/manual/009/qw5213.pdf

try this link below
http://support.casio.com/en/manual/009/qw1000.pdf

go here for the manual > http://www.gshock.com/support/

Anything more detailed about the replacement of batteries? Also, need to know placement of springs. Found a third tiny spring on my screwdriver magnetic) which may or may not be part of the watch… sigh!
Thanks!

You can get instructions from the Casio web site.

Go to the casio web site "casio.com".

Select "support" and the "manuals",
watches;

Accept terms

Select "watch manual archive"

you should be able to get instructions from the Casio web site.

Go to the casio web site "casio.com".

Select "support" and the "manuals",
watches;

Accept terms

Select "watch manual archive"

Read the number of the back of your watch and enter it into the search box

If you haven't got instructions on how to do this, you can get
instructions from the Casio web site.

Go to the casio web site "casio.com".

Select "support" and the "manuals",
watches;

Accept terms

Select "watch manual archive"

Read the number of the back of your watch and enter it into the search box

Click on my profile (escapement), then click on Tips and Tricks. There you will find link to all CASIO watch manuals.Rate me, please

Yes, go to "www.casiowatches.shriro.com.au/" where you should be able to find the information you need.

Click on "service agents" to find the address of your nearest agent.

I'll post in case somebody still needs this. This is the general procedure to switch the ATC 1200 from meters to feet. You can also switch the ATC 1200 (1170) from C to F. This is very helpful if you change the batteries and the watch gets reset to meters.

Also note, when you pull out the two batteries, you may not get the watch to come up. This is because of a race condition when the watch gets power. To fix this, look for the AC mark on the inside of the watch. Under this marking, in a little space to the left, are two copper pads. Short this out with a small screw driver to get the watch to ground zero.

To fix the Metric measurements:

1. Go to the home screen on the watch. This is when the the 3 letter abbr for the day is at the top. Also, if you cycle the mode button, it is the screen where the final beep is "high."

2. Then press the "memory" button, which will take the home display to the data screen. This shows current time, pressure and temperature.

3. Hold down the adjust button, until the set screen comes up.

4. Tab the mode/select button on the watch until you get a flashing C. Then press the memory button to toggle to F.

You can adjust all the measurements from this screen.