I inherited a braun 4169 immersion blender and it seems that the previous owner did not realize it could be taken apart for cleaning! it is totally stuck together- how can i take it apart properly? I've managed to scrape out all the dried stuff holding it together, but i can't seem to push down the little button to actually pull it apart, thanks for any help you can offer!

Contact his Customer Service

https://wolfgangpuck.com/product/cookware/

..

http://www.braunhousehold.com/en-gb/customer-support/instruction-manuals

http://www.braunhousehold.com/global/customer-support/instruction-manuals

Can it be that different for the other models listed at the above website?

www.service.braun.com/.../product.asp?...4169%7CHH%7CHH07%7CH...

If they do have a reset button it is normally underneath.

http://www.brothersoft.com/downloads/computer-manuals.html
you will have to type in the motherboard in the top search tab

http://help-site.com/c.m/

this site will tell you how to use something

http://www.manualsonline.com/

http://www.easyhelpguide.com/manual/ASRock.html

http://www.easyhelpguide.com/manual/index.html

http://www.easyhelpguide.com/manual/index.html
here are many manuals hope this helps you

Try pushing in the 2 small round buttons at the bottom of the base and pull up. That should do it.

4169 blender dismantling. this device is not suitable to be dismantled but this is how I did it. 1 disconnect from the mains. 2 lever off operating lever button at opposite end to hinge 3 insert sharp screwdriver into gap by top lid at same side as cable entry and prise off 4 heat up the casing with an electric paint stripper, wear gardening gloves. 5 when the casing starts to get pliable, insert a driver into the gap above the operating button locating lip and prise away as far as you can 6 do this with the locating peg on the other side 7 work between the two until the whole thing comes apart 8 lever out the motor, it will slide out once loosened 9 wash out the blender drive shaft with boiling water and detergent 10 dry out the body and soak the inside with silicone oil 11 work the blender blade until it spins freely 12 clean everything up and push it all back together 13 if any parts are deformed with the heat gun reheat them to a pliable state and reform them as best you can 14 if it is all loose when its back together, glue the joints with superglue and spray with glue accelerator 15 test it and if it's no good chuck it in the bin and buy a new one 16 but mine works fine.

I can sell you part of mine. I getting a new one to replace a part for mine.