Where can I find a manual for a Reddy Heater 125T?

Hi,
Here are a couple of tips that I wrote that tell you how to troubleshoot aTorpedo or Reddy heater...

Reddy Heater - Troubleshooting Torpedo Heaters Torpedo Heater Pump Pressure Adjustment
heatman101

/././

Hi,

Here are a couple of tips that I wrote that tell you how to troubleshoot a Torpedo or Reddy heater...

Reddy Heater - Troubleshooting Torpedo Heaters

Torpedo Heater Pump Pressure Adjustment

heatman101

=-=-\]][\

Old fuel from last season? Start at draining/cleaning the tank. Add fresh fuel. Check fuel filter and air filters. Test again.

Sears or Home Depot sell products and parts ... other than that.. hard to find

If you have one of these 125T Models- RH125AT, RHD125AT, RL125AT, RM125AT, RE125AT, M125AT, PKHD125T, TKU125T, UKU125T, RD125T
The web address is:
http://www.reddyparts.com/
There are 3 ways to order your part.

Sounds like a bad thermostat! (A common problem with this model) replace and it should work again!

take the side cover of and you will see where the fuel line goes into the tank. typicall the cap turns clockwise to remove and the filter is hooked right to the cap.

Here is a link to a owner's manual for a RL125T ... http://12.153.20.74/manuals/110429-01C.pdf. You can find a wiring diagram on page 19. I hope this helps you.

1. Does the ignitor glow for 5 seconds when the unit is started?
2. What is the air pump pressure reading?

These are the starting points for troubleshooting a heater that has an ingntor.

Answer these questions and maybe someone can get you started.

Are the ignitors intact? In other words, does the element make a loop back to the ceramic portion. The purpose of the LED is to notify the user of a defective ignitor. The other possibility is a bad control board.

If the ignitor is intact, but no power coming from the board (ignitor only glows for 5 seconds), then the board is bad or the fuse is blown. You might want to test the photocell while you are at it.

You will need to locate the correct model numbers to order the correct parts. "170T" & "125T" are only part of the correct model designation.

Post back if you have further questions.