Whirlpool adp 5550 - Dishwashers

IT CAN NOT BE SHUT OFF .

http://www.manualsdrive.com/captching.php?lang=en&search=WHIRLPOOL+DISHWASHER+ADP+252+VIEW+USERS+GUIDE#.U2zBnVf1WIw

It is possible that the machine does not start off the cycle because there are errors due to feedback from the inputs. For the program to start up the main program controller must initiate the INLET/MOTOR/DRAIN pump/ valve to open up and allow each function to be driven starting from the flow of water into the drum as also the drain valve to open to exit the water at the point of the program cycle. If this does not happen then the voltage at the valve/motor/pump must be checked or the fault relates to no voltage from the controller. This means the controller is a suspect.

Make sure that a fault in any of the cycle will relate to the specified action, so check the command from the program module and then the executing device be it the valve or motor or pump.

Please check the link below:

http://www.repairclinic.com/Washing-Machine-Troubleshooting?red=Washing-Machine-Repair-Help

Thank you for using fixya.

Whirlpool adp 6600 will not function start light is just flashing. Waht di I do?

It's a heating issue either a bad heater or bad sensor.

Managed to track down a copy of the manual from the Whirlpool website. The red light is an electronic indicator to show that there is no rinse aid.

There is a switch attached to the door latch that may need to be replaced. (the switch is inside the door).

My dishwasher isnt working anymore after i cleaned the filters? i took out and cleaned the filters in it and now it doesnt seem to be working properly. it goes thru the cycle but its not cleaning. the dishwashing tablet falls to the bottom and isnt even dissolved completetly after the cycle has finished. is it possible that its blocked somewhere?
It is a Whirlpool ADP 5540
thanks for your help
**** the walls are still dirty after the cycle but there is steam in there as if its done its normal cycle

replace the control board in the console