I have increase the ram from 512 to 2 gb in my emachine desktop, after i restart moniter not getting the video signal. how to fix it?

You cannot. See table below.
eMachines W3611 RAM Specifications Standard Memory 512 MB (removable) Maximum Memory 2.0 GB Memory Expansion 2 sockets Memory Comments PC2-4200 DDR2 SDRAM DIMMs. Supports Dual Channel DDR2. CPU Type 3.0GHz Intel Pentium 4 631 Model Comments 800MHz FSB, Intel 945G Chipset

hi

not every motherboard or on board video is compatible with windows 8

what windows was it running previously

windows 8 was designed for 64 bit platforms which requires 4 gig of ram but you have to also take into account the other hardware components and there maximum configuration

i have run win 8 on 2 gig of ram but it struggles with you tube downloads

i upgraded the ram to 4 gig and run win xp win 7 and win 8.1 on the hard drive

cheers

Hello, Jim.

Dell's official position is that the maximum memory for this PC is 1 GB. But, it may be able to support 2 GB, per Intel's specs.

But, to answer your question - yes - you can increase your memory amount to 1 GB. Since the system has 2 memory slots, you could conceivably have (2) 512KB modules (total 1 GB). If your system already has 1 module of 512 KB, you could add another. Just be certain it's the same type and speed.

Or, you could have a 1 GB module.

I don't think that your computer's life is in jeopardy, but additional memory always helps the speed of your computer.

Hope this helps.

There might be a problem with your RAM you may check your RAM and clean it with a cotton cloth and fix it again or change your RAM and see
Or the problem can also be with your moniter
thanks

Yes, it's possible to increase both RAM & HARD DRIVE Capacity.Your Pc comes with RAM: 512 MB in size and Storage (hard drive)Capacity: 80 GB.

You can put One more 512 MB of RAM or you can replacethe ealier RAm with 1GB RAM or Put two 1 GB RAM Instead.

For Hard Drive,use your 80 GB Hard drive as external storage device, and Put a 320 Gb new Hard drive.

Look closely at the BOLD print

Memory Upgrade for eMachines eMachines T5082 Computer, the eMachines eMachines T5082 Computer takes the PC2-4200 DDR2 SDRAM DIMMs. Supports Dual Channel DDR2. Memory Type, and comes installed with 512 MB (removable) of Memory. You can upgrade your eMachines eMachines T5082 Computer to up to a maximum of 2.0 GB Memory, the system has 2 sockets to install Memory, already with 512 MB (removable) standard Memory installed. For best Computer performance use the maximum amount of allowed Memory per slot for your Computer.
Choose the following Memory Upgrade for eMachines eMachines T5082 Computer.

no signal try open your system unit get the memory then put it back then try to switch on your computer

upgrade the RAM and find better processing speed of video card and using DDR3 memory

check your motherboard if capable of higher speed RAM..that will help too.

Hello,

You can use two 512Mb sticks which will equal 1024Mb or 1Gb.

Hope this helps.


DS

the other Ram is shared video
Shared video uses ram from your installed ram chips to use for your on board video adapter.