Hi. uL is displayed when the machine/motor control detects an off-balance load, and is steady on while the washer runs a mini-cycle to rebalanced the load. Display clears if mini-cycle successfully rebalanced the load. If the mini-cycle is unsuccessful, uL will flash until the door lid is opened, allowing the customer to view and redistribute the load.
the solution to this problem is not what whirlpool says in the manual, Think about it, if the machine detects an unbalanced load, would it not try to balance first, then if that fails, give the UL message? Why say UL and then try to balance the load?
To fix this problem, you would have to lay the machine flat, remove the centre allen wrenched bolt, take the rotor off (with the magnets). remove the four bolts holding the windings to the machine, remove the windings, unplug the wires and speed sensor. Now, if you examine the plastic housing of the windings you will see cracks in the plastic. There's your problem.
I remember a job I had on this very issue, and actually never could fix the darn thing. I replaced the speed sensor and and harness, and the problem remained. Had that winding in my hands and probably missed the cracks that were probably evident. I won't miss to check that next time. Thanks. BH
How does that affect the balance?
Why would this cause an off balance problem?
×
SOURCE: My whirlpool cabrio washer will not stay balanced
the repair man says i need to replace the inner tub for 299 dollars with a total price of 424 and its only 4 years old
561 views
Usually answered in minutes!
×