I have a Kyocera FS-2000D that had the error code 0150:0058881. Anyone know what that means? Thanks.

Error Code 6000 is fuser code, you need to replace the fuser unit, make sure there is no paper stucking there first!

I’m happy to help further over the phone at https://www.6ya.com/expert/mustafa_06f84c65ab5cc745

Call service message 6000 in Kyocera is a fuser error code. The fuser must have gone bad.

Regards,
Shrey

Error code 0150 is an engine EEPROM communication error. The engine board might need to be replaced. I have heard that sometimes a defective developer unit could cause this same error code. I would try swaping a develper from a working FS-2000D first.

0150 is a problem with either the engine board or the EEPROM chip that sits on the engine board. If you want to do it yourself, you can open the printer up and reset the chip on the board as well as reset all of the connectors that plug into the board. Otherwise, your best bet is to call a Kyocera service technician.

This seems to be a fuser error. You need to take it to your local sevice agent for repairs.

This error code means that the Laser unit in the machine has failed and will need to be replaced.

I have heard that 7410 is a standard code meaning the drum is out of position. Seat the drum correctly and away you go.
David
www.copycare.net

opa tbm to com o mesmo problema
alguem pode nos ajudar?
grato

I couldn't see a 159 error in the 2000d service manual, but I know 150 errors . They need to have their firmware updated, should be under warranty, their is a kyocera service bulliton on this issue so all agents can do your repair. It is just a matter of downloading firmware from kyocera. unzipping it to a mem stick or CF card and powering on your printer with it inserted, firmware then self installs.

The bits after the 159:is just page counter. Post Email if you want me to send you zippped firmware to suit.

install new firmware