Error F13 on Kenmore dryer He5 - Kenmore HE5 Electric Dryer

Check out this reply.........down the answer page..

https://www.fixya.com/support/t3388265-fix_code_f25_kenmore_elite_he5

I found this

F:50 - Water Valve Failure
F:50 flashes if no voltage is detected at the water valve relay.
? Check that the wires are plugged in on the valve and at the
relay on the electronic control. This fault code appears ONLY when in the Diagnostic Test Mode.

and then the OP said

Well the thermal fuse and the thermistor were both bad, replaced and the dryer is working fine.

Thanks for the help Jeff....

https://www.google.com/search?q=Kenmore+HE5+steam+dryer%2C+error+F50

..

What does the display say? Typically, these Kenmore dryers don't run because of a door latch error. We have had to have our door latch replace 3 times in 3 years. There is a lengthy trouble shooting program to bypass the latch error but it is time consuming.

Check all the thermostats for continuity.

The error code f01 indicates the primary control board failure. Before you replace that board I suggest that you unplug the dryer for 2 minutes then see if the error come back. If it does replace the board part number W10110641.

last on the list:

http://www.partselect.com/dryer+dryer-wont-tumble+repair.htm

does the door latch in place firmly?

just remember error codes are always going to be stored on every machine ,, shoukd not have a problem ,, but does it work

try replacing the door strikes and catches part # 279570...possible door hinge issue but less likely

I have a Kenmore HE5 Steam: after a power failure last week, now when you turn the dryer on and push"start" the cycle stops emediately and flashes PF...