Just bought a new jvc hdr60, and the clock won't stay set on the correct time. we have followed the directions, and the clock won't set.

To reset the clock on a JVC PC-110 boombox from 1994, follow these steps:

1. Press the Clock Set button, located on the top of the boombox, to enter clock setting mode.
2. Press and hold the Clock Set button until the hour digits on the display start flashing.
3. Use the Fast Forward and Rewind buttons to adjust the hour to the correct time.
4. Press the Clock Set button again to move to the minute digits. The minute digits will start flashing.
5. Use the Fast Forward and Rewind buttons to adjust the minute to the correct time.
6. Press the Clock Set button one final time to exit clock setting mode and save the new time.

Your JVC PC-110 boombox should now display the correct time.

Follow the directions for setting the calendar. Once you have entered the correct M/DY, the day of the week will display correctly.

setting the time zone on a "auriol radio controlled clock" is as follows: 1: press the Down button for 3 seconds and an F will appear in upper right area:
2: press the Set button for 3 seconds and the Hour display should now be flashing:
3: adjust the time to your zone:
4: press Set to complete

Please check if the wiring was done correctly. check the ground the all time +12 volt and the swittched +12 volt. If the set does not power up then I suggest that you MUST take the warrranty claim being a new set. Refer to the dealer before you can open the player so as not to void the warranty

Press and hold SEL (select) for more than 2 seconds so that one of the PSM items appears on the display.
Press number 2 button to to select Clock (clock should be above the #2.
The Clock HR (Hour) setting will appear.
Adjust the hour using the round left side control.
Use the up/down arrows (right side) to toggle to Minutes and use the dial to set minutes.
Use the up/down arrows to toggle to 24/12 and choose between military time or standard
with the left dial.
Press SEL to save changes.
Here is what appears to be your manual. See page 9 for clock. Save the manual to
your computer for future reference if it is correct.

JVC KD-LH300 Manual

There is a misprint on manual concerning setting the clock. This is the case for similar JVC mobile head units.

The proper way to set the clock for this unit is:

1.)Hold down 'SEL' button count to 3 seconds
2.)Immediately after release of 'SEL' button hit the '>>|' button

This will allow you to enter 'PSM' menu. Every time you press '>>|' it will cycle between, 'CLOCK HOUR','CLOCK MINUTE', and 'Demo' Mode.

3.)Adjust settings by using the 'turn knob' and make sure 'Demo' mode is set to 'Demo Off' for the clock to stay set.

Using trial and error, I set the time on my JVC PC-X250 boom box by:

1. Turn unit OFF.
2. Press and hold PROG/SET button until hour digits start flashing.
3. Use SEARCH DOWN and/or UP buttons to set correct hour (including AM/PM).
4. Press PROG/SET again until minutes digits start flashing.
5. Use SEARCH DOWN and/or UP buttons to set correct minutes.
6. Press PROG/SET again until time is not flashing.

o2bad455

Hold the SEL button down for more than 3 seconds. A sub menu appears. Use the track select arrow key to select the hours, rotate the volume knob to correct hour. Press track select key to select minutes, rotate volume to appropriate minute. press select again to finish. If this doesn't help, go to jvc.com, then go to support, then user manuals, enter model number. You can dowload the entire manual for free.
Good luck

this was very helpful with my problem