Labels feeding incorrectly on Z4Mplus Zebra priner

check the label margins, and label dimensions, and spacing , normaly is these problem, or is a printer driver problem, try reinstall driver

Resets the printer to factory settings or calibrate the printer by pressing the FEED, PAUSE and CANCEL, turn the printer and release the keys when feeding the labels.
Roberto Martinez

The label is not calibrated. Press keys FEED, PAUSE and CANCEL, turn the printer and release the keys when making the labels. Also verify that the type of material is NOT CONTINUOUS.
Roberto Martinez

The first mainboard of Z4Mplus falls short of this error and need replacement.
Roberto Martinez

Let the printer calibrates itself or have a manual calibration in the printer setup. You can also press the keys FEED, PAUSE and CANCEL, turn on the printer and release the keys when feeding the labels.
Roberto Martinez

Reset it to factory default.

I changed the print head, and the issue was solved.

iN THE DRIVER CHECK THE head TEMPERATURE ISSUE. Most certainly you do not heat enough to do the transfer.
Else your ribbon is not mounted correctly. Zebra has an out inking transfer film

printer manufacturers has different standards depending from the varieties of model and brand of printers for example an epson printer model who is older version is not the same speed print with the recent model likewise with the other brand. Therefore calibration of labels is depending to the version of the printer you are using now.

Set the printer to transmissivefrom reflective gap sensing.

This will cause the printer to loog for the inter-label gap to tell it where the top of the label is at.

Steve Weinrich
LazerTek, LLC