Question about Rangemaster Kitchen Ranges

1 Answer

Hi, I have a hard time to find light bulb for your hood. What is says under the hood is that is takes type T8 light bulbs, do you know where I can buy them? Thanks,

Posted by egrela on


1 Answer


  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 8,197 Answers

You can buy a T8 bulb at your local home depot or home improvement store or you can go to the link below.

Good Luck and please rate 4 thumbs up for the free answer

Posted on Aug 07, 2010


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a roper microwave that sits above my stove. model MHE14XMP-3 made in November of 2005. what light bulb do I need for under the hood? I tried a

strange! Sounds like a faulty bulb as it is correct. I read to unplug the microwave when you replace the bulb.

  • Replacement Roper MHE16XSQ0 Light Bulb
  • Replaces Roper 8206232A Light Bulb. Same great brightness guaranteed.
  • Superior-crafted filaments for long-lasting brightness
  • Quality glass and packaging so bulbs will show up in factory condition.
  • Specifications: T22*55mm E17 130V 40W

Roper Microwave Parts

Amazon com Replacement Light Bulb for Roper MHE16XSQ0 Microwave Compatible...

Roper Microwave Parts Roper Microwave Repair Parts

Se this link which suggests a replacement board

Under Hood Light bulb is fine brand new

Aug 18, 2018 | Philips Televison & Video

1 Answer

How to change bulb thats a t8 fluresent fixture in a home

A Lot of the T8 style have very little room to move the tubes around, check a few things:
See if you need to remove the tubes in a specific order,
See if the ends of the fixture are removable,
Instead of dropping both ends of the tube drop one side first,
Sometimes after the tube has been twisted and dropped slightly you may have to maneuver the pins to avoid the fixture.

Dec 11, 2012 | Philips 6996C FKD 230V 1000W Lighting

3 Answers

How do I remove burned out light bulbs from zephyr range hood? What do I replace them with?

What model range hood do you have? To remove most of the bulbs from a Zephyr hood, wait for the bulb to cool after use. Then rotate the bulb counter-clockwise about 60 degrees (less than a quarter turn) and the bulb should drop down. If you have problems turning the bulb, try the glass suction cup that comes with the hood or a rubber/latex glove grip. Sometimes a rubber jar grip will also work.

The one way to find out your range hood bulb may be to remove one and look at the side/back. The bulbs are labeled. Otherwise, check your manual. Zephyr has the manuals for most of their ranges here: . Use the drop-down menu to select your model.

Different hoods use different bulbs. For AK6500, 6536, 6542 Cyclone hoods, purchase type: 4OR 14 mini flood light bulbs. For the AK2500, 2536 hoods, you need to purchase type GU 10 halogen bulbs. For the Anzio models, including the ZAN-E30AS, get a GU-10 50W halogen bulb.

I hope this helps.

Cindy Wells

Oct 14, 2011 | Kitchen Ranges

1 Answer

Replacing old flor 48" tubes

There are three types of fluorescent 48" bulbs t 12, t8, and t5. they are not interchangable. if you have a fixture that has a t12 type ballast, it will not light up the t8 bulbs. you have to change the ballast to a t8 style. just to clarify, the number stands for 10ths of an inch in diameter on the bulb. a t12 is 1.2 inches, a t8 is .8 inch and a t5 is .5 inch.

Nov 20, 2010 | Microwave Ovens

1 Answer

Change bulb in ford focus

Hi Harper,if its one of the front lights there's a plastic back when you open bonnet/hood.Take off plastic back,very easy.Unplug the block attached to back of bulb.There's a steel clip which you release & bulb pops out.Replace new bulb & follow same steps as taking out. Try not to handle glass on new bulb.If its backlight again very straightforward.Just make sure bulb on back is the same,only 2 types,single & double connector.Hope this helps mate.Let us know if you got it done.

Aug 11, 2010 | 2002 Ford SVT Focus

2 Answers

Dont know how to take lightbulbs out of cookerhood

How do I change light bulb in my windcrest hood and what type does it take?

Mar 09, 2009 | Kitchen Ranges

1 Answer

Low beam bulb on 2003 X-type

Hi Rod

Open the hood, remove the plastic dome cover, and then the bulb connections, un clip the bulb retainer, extract the bulb, and check with the new one that its same.
No fingers on new bulb or it will pop when you switch on.
Fit new bulb and retaining clip, refit wires, test it, then fit plastic cover.
Good Luck !
This is what it looks like under hood !

A FixYa rating would be appreciated Thank you !

e3ac4f3.jpg John

Feb 08, 2009 | 2003 Jaguar X-Type

2 Answers

Bulb has blown on one of the lights but the other light will not

Its definetly the control board again.

Its worth $110.00
Read other answers ive given to others about similar problem


Jan 22, 2009 | Kitchen Ranges

2 Answers


You have to take all the facia off the dash - and then pull the dash cluster out. It is a long hard job for a light bulb. When you take the dash out don't forget to undo the speedometer wire and then the wire plugs on the left and right upper sides of the dash unit.

Jul 17, 2008 | 1997 Buick LeSabre

1 Answer

Need help.

Open the hood, and you'll have to reach around under/behind the headlight. Feel for the electrical cable going to the bulb. It should attach to the bulb with a round plastic hub that you can rotate to detatch and remove the bulb from inside the engine compartment. It's very tricky if you have big hands, and there's really no secret to doing it, just take your time and don't get frustrated if it takes a while.

Remember, when you can feel (it's really hard to see) the round plastic hub the wires connect to, gently but firmly rotate the hub until it detaches, then carefully pull the bulb out. Remove the dead bulb, insert the new bulb, and then gently reverse the process, being very careful when inserting the hub and bulb back into the headlight. Then rotate it the other way around and close the hood - you're done!

Good luck!

Jun 10, 2008 | 1993 Honda Civic 4 Door

Not finding what you are looking for?
Kitchen Ranges Logo

Related Topics:

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Rangemaster Kitchen Ranges Experts

Ismael Rodriguez...

Level 2 Expert

184 Answers

Paul Carew

Level 3 Expert

3512 Answers


Level 3 Expert

13434 Answers

Are you a Rangemaster Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides