Epson workfroce 610 prints crooked

check the paper tray, make sure the paper guides are snug up to the edges of the paper. Even a small gap will cause miss alignment of the printing.

have the printer being discussed in this thread.... the Epson WorkForce 610. I just encountered the same issue, many lines were missing from the page that I wanted to print. Ink levels were fine, but every time I try to print the same thing, the same lines were missing. I read through the solutions mentioned above and I decided to see what the printer had in its maintenance toolbox on the printer itself.

Here's a solution that worked for me!

1. Go to "Setup"
2. Under Setup, select "Maintenance"
3. Select "Head Cleaning"

The printer does the head cleaning automatically. Print another page, all of the lines should show up!

Simple, no need to buy another printer or clean the ribbon...

Try using HP Support

HP Photosmart C6280 All in One Printer

Here is a manual to set-up the network: http://www.ehow.com/how_2036282_remove-dvd-player.html. Pages 4-8 should get you were you are going. Good Luck!

I would try holding the printer upside down and gently tapping.
There maybe something stuck in the paper in slot

On the Epson website it is confirmed that the Epson WorkForce 610 will not recognize transparency media. It is just the way the printer works; if it can see through the media, it doesn't think it's there.
However.....you can tape a sheet of white paper to the non-printable side of the transparency, and it prints just fine. I put two strips of scotch tape on either side, top and bottom. Works great. It's kind of a hassle, but better than not being able to print transparencies at all!

Hey. I too am having that problem with my ip1800 canon printer. It makes a weird "clicking" sound whenever I turn it on, and then when I try to feed it paper, the sheets either get stuck and become crooked and cumpled. OR, when it does sound like its printing, it doesn't print on the page--maybe the tip of the page, but not the whole page.

The epson printer RX 620 only prints partially for my photo while I want the whole picture. How do I get it to print the whole thing instead of it printing it partially?

Are we talking about a paper feed problem from the paper cassette tray or the Auto Document feeder on the top. Either way, check the the paper width guides, or if it is the paper cassette tray, remove it and check the paper pick up roller locking clips.