How do you put on a blade when you took it off?

Do you have more parts in your hand than 2x screws and 2x blade parts? If no then pop the small cutter blade onto the plastic blade drive with the drive engaged into the diamond shaped hole in the cutter blade. Make sure you put the cutter blade on with the teeth facing forwards and the correct way up. The top side (goes towards clipper) is pretty much flat except where teeth taper. Next lubricate the small cutter where it is going to touch the large comb blade when you fit it. Now put the comb blade on and fit the 2 screws. Line up the blades & tighten the screws.

if there timed blade there will be nottches for them to go in if regular blade just put the on put the curled -part of the going toward deck this is up if fin points down that is bottom install blade up blade toward deck bottom this will circulate air through shoot for grass ejection all done

I think that you may have put the blade on backwards. try taking the fan apart and reversing the blade around and reassembling the fan.

Have you tried running it with the blade back on? It may be ok as there is a braking system built into the pto clutch that makes the blades hard to turn by hand. Regards Phil

i needed to replace my blade - my husband replaced it but it would not cut so we took it apart and cant figure out how to put it back together. nothing helpful on line.
did anyone have a link how to put all the pieces back together to create the blade? thanks

Dont know exactly what you mean, but turn blades with cutting angle up. Make sure if a star like center on blade is lined up and goes over the star like on shaft and tightned bolts. If it has a tray like blade holder, just put up against it and tightned bolt. The way to remember is to put the cutting edge angled side up.

Make sure you put the blades back on the exact same way you took them off. Because in order to for them to cut they need to put back on the way they came off.

remove completely redue

Okay I fixed mine. this is I what I did and it works now take the big blade and put it on a table, take the little blade and put on top of the big blade if you look closely at the big blade you can see where the little blade went, make sure you allign the blades. next take the white thing dont know what you call it bit it rotates the blades put that on the little blade, take the gold piece align with holes to the big blade and take the silver piece allign with holes and then put the screws back in. when you put it on the clipper make sure the white piece goes in the hole that rotates the blades and sould go in fine

there is something to do with the balancing of the blades

it would of been better to send them in to be sharpend...they charge 10 bucks for this service in australia


best send the blades in