Model 6233 Singer material will not feed needle goes up and down

The feed dogs on the 7033 shouldn't drop down. This model uses a cover over the feed dogs when doing free-motion sewing. To remove the cover, raise the needle and presser foot. Open the slide plate over the bobbin by sliding it towards you. Lift up the front edge of the cover and pull it away. Close the slide plate and lower the presser foot.
Many Singer manuals are available here: https://www.singer.com/support . The current link to the 7033 manual is https://res.cloudinary.com/singer-sewing/image/upload/fl_attachment/Singer-Website-Library/outdated_product/SINGER_7029_7033__7035_and_9410_Sewing_Machine.pdf . The cover is shown on page 8 of the manual. See page 12 for the picture of removing the feed dog cover.

I hope this helps. If the feed dogs are actually down and not covered, there is probably something broken in the sewing machine.

Cindy Wells

Nesting on bottom (wrong) side is almost always a top thread tension too low issue. Try a contrasting top thread color to be sure.

Be sure to follow the manufacturer specific instructions for winding bobbin and threading. The unit has a horizontal spool so be sure to use a spool cap that is larger than the spool. Be sure needle us fully seated and not bent, replace when in doubt. Be sure rotary hook and needle are not making contact.


See following video on testing thread tension.

https://youtu.be/YF7EOCvpHLg


Manual, free download, no registration.

https://www.manualslib.com/download/641380/Singer-6233.html

Have you accidentally altered the control for the feed dogs.not familiar with your machine but on mine it can be done

Do the feed dogs move above the surface of the needle plate? If not, then the feed dogs have been dropped for darning or they have seized from lack of oil.


Wheel on right side that controls the needle up and down is very tight...

that machine has what is called a 6 second threading style, you just snap the thread at the top first thread guide then take the thread down around the curved part then up over the take up lever then straight down to the needle. be sure your presser foot is in the raised position when threading the upper thread.

try using maximum stitch length, if still not working try removing needle plate and clean you teeth

here is a link for a free manual, check to see if the feed dog lever is up in the sewing position, if the feed dog lever is down then try to raise it up. if it will not raise then the machine needs to be check to see what's wrong with the feed dog.
http://www.singerco.com/uploads/download/6dc4cd61b0c61a5fc13e60785f01d29199328059.pdf

have you checked your feed dogs are moving? have you dropped the feed dogs by accident? the feed dogs might need a drop of oil on the moving parts inside your machine.

Call Singer at 1-800-4singer and they will help you. I think a piece of the needle may be stuck in your feed dog

hi! there,
feed dogs are mechanically connected to shuttle race link.everytime shuttle race rotatate and needle goes up and down the move relative to its timing order.there is control knob on feed dogs to release or goes down permanently not to move,on the right side of machine.if you push down feed dogs go down.try to find this one,if you can't try to see uder the machine if there a loosen parts behind shuttle race holding feed dogs.tighen this up.hopefully this could help you,have a nice day,just rate me thank's