When on line after a fews minuits i lock up and have to restart explorer

you must have to visit a mobile software and Hardware repairing shop and just ask your problem....it will be solve in few Minuit ....because of to read lock passward need a flashing box..which is available at repairing shop

Are you able to manually empty the water out of the machine (Usually there is a little tube behind the plate at the front of the washer)

After that turn the machine off and unplug from the wall for a few minuites to see if this will restart the machine.

http://www.ssgames.co.uk/
http://www.hometurnedpens.co.uk/

thers electric components gittn hot from wear--resistence builds--u need a scan that shows values-an independent mech has vehicle specific gear to do this--may b as simple as a coil or module-but dont replace mor parts til ur sure--a cheap code reader in a auto store wont help u

check your timing, check that your ignition pick up coil is good. also check your fuel pressure. and check for any vacuum leaks. double check your coolant temp sensor to the ecm it tells the ecm what temp it is and the ecm adjusts the fuel amount accordingly.

If your tank had black stuff in bottom check fitting for line going in fuel tank take piece of fuel line look if inside is swelling close and soft ethanol fuel is ******* rubber replace lines don't cost much

the gauze filter on the ned of the pick up pipe is blocked with clutch and brake band dust ,drop sump and clean it all out ,refill with new oil and sell it quick

would help if knew the bran and mod#,sound's like you have a bad motor.

As I was reading your complaint without looking at the model and I knew you had a Ford. the ford door lock accuators are very weak. It will make a sound that makes you think it is locking, but it won't. If you do it a few times it sometimes will lock.

By all probability you need a new lock accuator. It is not a major epence.

Hope this helps.

Sounds like the motor is locked up.

Hi!!
I think that it's a hardware problem!!