Whirlpool Duet Sport Error Codes - Washing Machines

Whirlpool Duet Washer Fault Codes

try unplugging and plugging back in. a reboot of sorts.

i am not a repair man, but I own one too. good luck.

The tech sheet is located under the kick /service panel in a jacket. Suggetions and codes are in it. Duet sport service manual

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

The following list of codes indicates an electronics communication problem with the washer: - Duet HT washer - F01, F03, F06, F11, F23, F24, F27, F28, F29, F30, F31, F32, F35, F42, F61, F62, F63, F64, F65, F70, F71, and F99

If Pause/Cancel does not work:

1. Unplug washer or disconnect power for one minute.
2. Plug in washer or reconnect power.
3. Re-select the cycle and press Start.

NOTE: If the error remains on the display, call for service.

I would first replace the door latch/lock assembly, a number of users have and it fixed the F-11 error code completely. Its the cheapest part for this problem.

Hope helps.

inside the machine should be repairmans instructions. this includes explanations for all the error codes.
you will have to remove the front access panel

I have a whirlpool duet sport electric dryer with an error code of F 26.

hi there

i read your report heres the site for your codes
Whirlpool Duet Washer Error Codes Topic: Whirlpool Duet Washer Error Codes (Read 5660 times) ... Whirlpool Duet Washer Error Codes " on: September 13, 2008, 10:38:25 PM " Logged. John Pahl ... appliancejunk.com/forums/index.php?topic=1785.0 - 81k - Cached

ty for writing to fix ya
best regards Richard

serial communication error between central control and motor control.
Check connections at ccu (top front right corner) and mcu (bottom by motor), check belt drive for wear.
Did motor run ? Any other codes in diagnostic? (any one modifier button 4 sec on 4 secs off 5 times.) F codes are failures and C codes are portions of test cycle(automaticly run)

My machine had the F21 code and the inlet to the pump was blocked with change, bobby pins, small rocks, pieces of fuzz and clothing. Removed the front cover of the mahine and removed the cap on the front side of the pump and cleaned this trap area out. The pump motor quit humming and the machine worked like it is supposed to!

Thanks