I do not have the installation cd for my palm m130

Try to do this simple step:

1. Copy the underlined link below and paste it to the address bar of your browser. You'll see the manual for your smartphone. I hope this helps you solve your problem.

http://www.retrevo.com/support/Palm-m130-PDAs-and-Handhelds-manual/id/281ci262/t/2/

download here

http://kb.palm.com/wps/portal/kb/na/m-series/m130/unlocked/downloads/page_en.html

http://kb.palm.com/wps/portal/kb/na/m-series/m130/unlocked/downloads/page_en.html

This is the link to the Palm site and manual download.
hope this helps.
Ed

have you fully charged the battery?
Have you tried a reset and a hard reset?

hard reset, push the power button and the reset button at the same time. (All data will be cleared)

Hope this helps.
Ed

The solution to this problem is.. if the m130 still has all the data, then

you need to perform a custom hotsync to overwrite all files on the computer

1. Click on the ‘Hotsync Manager’ icon and choose ‘Custom’.
2. Highlight the ‘Datebook’ conduit and click ‘Change’.
3. Select ‘Handheld overwrites desktop’ and click ‘OK’.
4. Repeat these steps for the ‘Address’, ‘Todo’, ‘Memo’ and ‘System’ conduits.
5. ‘Install’ and ‘Install Service Templates’ should be ‘Enabled’.
6. Perform a ‘Hotsync’ operation by pressing the button on the Hotsync® Cradle, or Cable.

Now that the files are on your computer you need to sync them into the new palm

Same steps but this time Desktop Overwrites handheld

1. Click on the ‘Hotsync Manager’ icon and choose ‘Custom’.
2. Highlight the ‘Datebook’ conduit and click ‘Change’.
3. Select ‘Desktop overwrites Handheld’ and click ‘OK’.
4. Repeat these steps for the ‘Address’, ‘Todo’, ‘Memo’ and ‘System’ conduits.
5. ‘Install’ and ‘Install Service Templates’ should be ‘Enabled’.
6. Perform a ‘Hotsync’ operation by pressing the button on the Hotsync® Cradle, or Cable.

Compatibility related to Operating system rather than computer's model. All you need to download Palm desktop software at : http://kb.palm.com/wps/portal/kb/common/article/33529_en.html

my palmm130 fails to sync the addresses with recently fitted windows 2007

Try to check at the back of your palm there must be a reset button. Just press it on hold within 10-20 seconds and don't turn-off the devices while resiting.

Hope it is helpful.

Hi, connect your wife's palm to the pc , click on start , go into all programs , browse for palm desktop and inside palm desktop you would see mail setup click on that .... Regards

Create a new Sync profile and check it again