My printer scans an Image then when the paper goes through it gets stuck half way and says carridge jam

Frances;
I'm not Lexmark certified; however, paper motion fails are generic in nature. Paper motion fail can be a bit difficult to diagnose at a distance...
* If it jams at every sheet then check to insure there is not a bit-o-paper stuck from a previous jam.
* If it has been an issue that has been increasingly getting worse than I'd replace the pick-up roller(s)
* Lexmark's support page for your printer is below. (You can also find a service prover too)
* Parts order for your printer is also below. You can determine at the support page if your comfortable replacing pick-up rollers in that model printer.
support lexmark com Service Parts
Note:
* Frequently people tear a jammed sheet when it comes out leaving pieces behind. BAD! When you get a torn sheet in your printer insure you retrieve all the pieces. Those left behind guarantee a jam on your next try.
* Paper jams not caused by debris in the path or worn pick-up roller(s) is beyond user maintenance.

it would be better if you feed the printer the papers one by one manually
try it and see if it works

Try this...

E represents error
so make sure you try some resets like
disconnecting all the cables from the printer and keep the printer idle for sometime
so there could be issues on the cartridge or on the hardware of the printer so
check the cartridges
if empty (replace them )
if dirty clean them with a clean cloth
then check whether if there's paper jam or carridge jam
if so try to remove the jam
remove the jammed paper from the back of theprinter

It will re-print it after you clear the jam. Just pull it out pulling slowly and evenly and it will come out.Also you can see directions on HP.com. Steven 818-888-0006

Hi there ok Generally when this happens, something has fallen into the printer, or a piece of paper has been jammed in there.

First step, remove the ink cartridge, and turn the printer upside down and gently shake it, see if anything comes out.

If nothing goes, or you can't hear anything rattling around, get a piece of cardstock paper (60lb or heavier) and gently push this through the printer, to see if it will help push out what might be stuck in there

Please come back and just gave a vote, it will gave me some satisfaction to know am helping some one so I will keep on helping.
All The Best: Pineworks

take the carridge out and reload it back in and the paper to.

Look at the paper path very carefully. There might be a piece of paper that got torn off and is either jammed up in the fuser or the registration assembly.

Turn the printer off. Then move the print head back to the center with your hand and turn the printer back on.

Try this...