No display Received wristwatch & monitor in February. will not turn on , tried troubleshooting.

Most likely the battery is defective have it replaced.

I'd look on eBay at the completed auctions as a guide.

I have tried el Greeko's solution, which is the manual's solution, and my analog time still does not move. There is a capital R displayed in the top right corner of the watch display.

You can adjust the analogue hands without changing the digital ONLY when you have set the watch to 24hr fornat. Do this by going to the second Timezone screen (T2) and pressing the crown once briefly. If A or P appears, the time display is in 12-hour mode. If no letter appears, the time display is in 24-hour mode. To change mode, press crown briefly a second time.

Now go to the basic display where no digital info is shown. Pull the crown out. Now slow turning will adjust the minutes and fast turning the hours, but only of the hands. Therefore you can synchronize the two. After they show the same time, press the crown back in and adjust both times together using the crown as normal on the standard "Time" digital screen

If its the 4 button watch, you hold in the bottom right, which sets it to alarm, and then press the top right button. It bleeps at each press and turns on/off the alarm display.

mcdevito75 here, Casio watch with the LCD display, any wrong pressure on this display and your Casio is ruined, the liquid display can break very easily. BEST BET, look for a small watch repair shop in your area for this battery change.

CLick mode until you get to time
Hold set button until chime is displayed
Clcik mode again until 12 hr is displayed mode agiain to hr St/sp to to incresse time Reset to Decrease
mode to cycle thru

set to finish

Hi Dude, it's one of those things your going to cuss once you know. Just unscrew the Bezel.Thats it. Steve