IBM mouse stops working intermitently

IBM ThinkCentre S50 8183G1U Drivers Download for Windows 7 8 XP Vista

Get new mouse.. Don't buy 10$ mouse.. Spend $15 or more.. Big difference in life.. Usually..

It's quite possible you have a FireWire port with hardware problems. The fix is somewhat costly, because it requires a logic board replacement. You need to bring your machine in for service.

The engine faults should have shown the problem. Get one of those code readers (about $40) to read the problem.

Possible insidious shutdown causes I can think of:

1. Failure (intermitent) of the fuel pump relay.

2. Failure of the fuel pump (also intermitent)

3. Failure of engine rotation sensor (intermitent) This device kills the fuel if engine rotation ceases to be SENSED and would cause the problem. It is a safety to prevent the fuel being pumped should a crash occur and engine isn't running.

Relace the temp sensor for the fans.

At the back of the Mouse, there will be small flushed 'reset' button. Press that. It resets and reconfigures the connection.

Have a nice day :)

Replace the solenoids on the gas valve. These are often intermittent befor total failure. Hope this helps!

It probably just freezes due to too many tasks. After all that laptop doesn't have a lot of RAM, it's a great device though, i have the same one.

LOOK FOR A BUTTON TO RESET THE MOUSE AND THE USB CONNECT SHOULD ALSO HAVE A RESET SWITCH ON THE USB CONNECT YOU NEED TO PUSH BOTH AT THE SAME IME SO THE CAN GET INSINK OR THE CHANNEL TO SET. SOME TIMES THE MOUSE HAS TO BE TAKEN APART AND CLEANED JUST LIKE THE OLD MOUSE BALL ONE, AND RESET THE MOUSE SETTING IN CONTROL PANAL, UPDATE DRIVE MAY ALSO HELP IF THERE IS ANY NEW FIXS

ROD

PS SOME TIMES THE LEAD TO THE BATTARY CONNECTION NEED THE THE SPRING PULLED OUT A LITTLE OR THE OTHER END WITH METAL TAB ON IT NEEDS PULLED OUT BECAUSE THE PLAY IN THE BATTERY COMPARTMENT IS LOOSE AND THE CONNECTION IS INTERMITTING A VOLTAGE CHANGE AND CAUSES THE MOUSE TO LOOSE ITS SIGNAL TO THE TRANSMITTER OR SET FREQANCES.

ROD

Replace both convergence IC's part# STK392-040. Also check for burnt/discolored resistors nearby.