Error code E:62:20 meaning

A letter and number error code of E:61:xx , E:62:xx , or E:91:xx is an indication a malfunction has occurred in the camera. To try resolving any of these error codes, power reset the camera back to the original factory specifications.

I'll forward a link to a page where you can view the information about power resetting the Camera.

Please click on the link to open the page to view the troubleshooting steps.

http://www.kb.sony.com/selfservice/documentLink.do?externalId=C265373

Thank You!

Hello,I'm sorry but this error code has nothing to do with Windows software or memory card error as indicated above. The list of error codes can be found at https://www.sony.com.au/electronics/support/articles/00008857 : E:62:10 is a very well known and recurring problem with a lot of Sony camera's and indicates failure of the stabilizer. I found more than 300 forums discussing the problem, please read http://sony-e-62-10.atspace.cc/. A temporary solution is available on https://www.youtube.com/watch?v=S53D3EfDVk0. Hope this helps.

Hi!
It's a flash error. Could be flash fuse or flash board. If you have a multimeter and you're ready to open it, contact me at [email protected] or contact your local Sony service center.
I work in a Sony service center.

Tom

Press HOME> SETTINGS> MAIN SETTINGS> INITIALIZE> OK

Shake camera whilst it turns back on..may have to repeat a few times
The error E:62:12 is with sensor that tells to the camera in what position is it. (hor, ver..)

hope this helps you.

You are getting a lens error and it needs replacement. replacing the lens will Solve all issue you are having.

errorE:62:20 related to lens unit stuckup or gears problum repairable

No Problem! Press MENU end go to setup, choose initialize to initialize the cam and put all the configs! finish! your problem is over.

Sorry for my english because i'm from Brazil ^^

Hello, I have same problem with dsc-t10, when I open my camera than I found 3 motors, two of them on the right of the lens, these are to adjust the focus. One of them was broken.

easily just reset the camera with a pencil.

Hello, this error message means that there is an melfunction in angular velocity sensor, peripheral cicuits. Simply speaking steady shot function does not work well. Please contact nearest Sony Dealer. Best regards, Arpi