Error ##334., its my problem
The error code ##334 represents a EEPROM
check error. The manual says this means the Printed Circuit Board may
need replacing, however, try this procedure.
Insert paper into
machine.
1)To enter service mode press Menu, copy, #
2) Select Test Mode
with the + or - keys
3) Press OK
4) Press 8, lcd shows 'Please Wait',
after wait, press 3, the lcd then alternates between 3-0 (EEPROM clear), and 3-1 (Purge flag)
5) When EEPROM clear (3-0) shows in lcd,
press 0, then OK, then Stop then press the OFF button.
Repeat the above from Step1 to step3
in step 4 this time reset the Purge flag by pressing 0 when 3-1 shows in the lcd, OK, Stop, Off.
If
the red fault light is still blinking press Resume.
hope this helps
I have the same problem, tried that didn't work.
error ##343
same problem. Have gone through all maintenance procedures to clean heads. Error message #336. Wait cooling and check printer and press resume cycling through on alarm panel. Print quality has slowly been getting worse over the last few uses but now won't print at all. Sigh !
×