Washer continues to run,does not go through the wash progrmme

I presume youmay have a virus in the system that is blocking the site. Please remove/ delete all temporary internet files, cookies, recently installed add on progrmmes and try again. You can also checck out from another computer if you are denied access in which case yourr account could have been hacked. you can send a message to the provider for help. hope this helps

the water valve that connects the inlet hoses to the machine is stuck open and needs to be replaced if the water continues to run after you have turned the machine off

please the scaner driver cds put in cd-rom other cd dariter and instoll the scaner driver ane location in c drive in instoll
and start the scaner and opening the user progrmmes and start job
and second time adobe photofhop progrmmes is instoll and open the photoshop and scan in and you chouse the file just tiff - jpeg -other select and ok this file other progrmme in workink file ok

if it is not changing cycles the timer may be shot

Yes there is it is the water valve the part that your hot and cold water hook up to.You will need to replace that part Hope i helped:)

CHANGE THE LID SWITCH

Littleone.. please check your instructions.. some washers now dont need Hot water connection to them...they heat their own as part of the efficiency settings on the wash programmes themselves!

Regards Faggly

I would check the water level switch. If the switch will not activate the washer will over flow with water and not start the wash cycle

dudett, uplug the washer and turn the water valves on. If the washer is filling with the washer unplugged the valve is bad. Part number 22001196. Not a hard job. If you need help installing, just e-mail the cat here at [email protected] Catriver..post back.