At view window it say please wait condensation operation paused can it be fix

Condensation can form inside the camera if you take the camera from one environment to another where there is an extreme temperature change.
Simply wait until the condensation disappears. The warning is to protect tape and camera.

put the oven on low wait till oven is hot but not hot enough to melt anything put cam corder in for an hour then let it cool gradual before romoving it then try it

This is often referred to as DEW and is a sensor inside the camera that detects moisture. You can hasten the removal most times by warming the camera with a hairdryer on medium setting and not too close to the plastic case. When you store the camera store it with a few of those little bags of silicone crystals that come in many packages that we just throw away.

Please rate our help to keep the service online

Honestly if you had it fixed for $100 you got a bargan. The dew sensors mount on the loading motor and these do fail. It cound need replacement. make sure the connection from the loading motor is good to the main board.

I found instructions with pictures on fixing this problem online at
http://www.freewebs.com/ltooz/03jvcgrd70u.htm
The process involves taking the camera apart.
Other forums I have looked at have mentioned waiting the error out or allowing the camera to air out.

Here is how I fixed mine

JVCgrd70u Condensation problem fixed

Hope this help,

Louis

If the camera becomes damp or cold and brought into a warm atmosphere damp forms in the mechanism which would cause the tape to stick and become damaged or fouled.

leave the camera to warm up for a few hours and the fault should clear.

If not the most common reason is the dew sensor has failed and needs replacing

If the camera becomes damp or cold and brought into a warm atmosphere damp forms in the mechanism which would cause the tape to stick and become damaged or fouled.

leave the camera to warm up for a few hours and the fault should clear.

If not the most common reason is the dew sensor has failed and needs replacing

If the camera becomes damp or cold and brought into a warm atmosphere damp forms in the mechanism which would cause the tape to stick and become damaged or fouled.

leave the camera to warm up for a few hours and the fault should clear.

If not the most common reason is the dew sensor has failed and needs replacing

try removing the battery and take a clean soft cloth and gently wipe surface.