I have a kenmore elite he3 front loader washer. it gives me a f11 code when i attempt to wash a load.

if its a Kenmore model then this message says that the button control board has lost sight of the main control board , but its been my experience that this maybe able to be reset and it may never come back or it will not reset and the control board will need replaced (50/50)


cycling power may reset this

uE error code 79631512210 Kenmore Elite Washer - Sears ...

www.searspartsdirect.com > Ask an Expert

Jan 10, 2014 - uE error code 79631512210 Kenmore Elite Washer ' SearsPartsDirect. ... After unloading the washer completely, the machine attempts to rebalance the .... to ensure proper fit and to keep appliances running for years to come.

UE Error code on my front loading Kenmore washing machine

www.shopyourway.com > Manage My Life > Questions

Jun 13, 2011 - I have a Kenmore 3.5 cu. ft. front loading washing machine (model #4027) and it is 1 year old. ... what does the F35 error code on my kenmore elite front loading washing machine mean? F13 code on Kenmore Elite HE3 front loadingwashing machine.

The symptoms are pretty specific for the F11 code on the Whirlpool Duet front loaders and clones (Kenmore Elite and KitchenAid):

If the washer starts to fill but the drum NEVER moves, your MCU is bad

If the washer runs through most of a cycle and then gives the F11 before (or during) a rinse or spin cycle, then you have the CCU relay problem.

If you are interested in having me repair your CCU for you, I offer that service on eBay (website coming soon). My username there is "jhagner"

Thanks

A bad CCU (main control circuit board) will cause this F11 problem 90% of the time

either way too much soap or the wrong type,run a couple of washes,without clothes to purge excess soap and see if this clears up the sud code

yes!! the F/11 is triggered under high voltage conditions like high speed spinning. The part is called the MCU motor control unit. if it goes into failure while using your machine and locks the door, just wait 3 minutes and the door will unlock after the MCU resets. Try using you machine with a low speed spin for awhile.

Most of the time its the thermal fuse part # 3390719

Remove the lower front panel 3 screws across the bottom. Pump will be behind this panel.

There is an override switch directly below the latch under the machine on most front loaders.

ok " there is a filter on that line ,it has to be cleaned

to locate filter, follow hose back to filter

filter will come apart for cleaning