I have a sony 1652z amp & need to know the best way to wire 2 mtx 10'' blue thunder subs
in order to solve this problem you must figure out what type of enclosure gives you the sound you are looking for and take into account the area this enclosure will be placed in and does that combination allow you to efficiently run your subs without overpowering your components ( subs, amps, ect). there are many options on wiring your amp and depending on the options on your subs such as dual voice coils, you have a really good chance to get the sound you are looking for if you just do a little homework and make the most of your entire audio system. dont make the classic mistake and just toss your system together and start cranking up the power on your amp to get the sound you want because you could possibly loose your amp, subs, or worse like your cars electrical system. if you have to turn your amp past the three quarter mark, get a bigger amp because heat is going to be a big issue and sony amps will shut down into protect mode almost every time. get the specs for your equipment and see what options you have as far as bridged or single channel, how many ohms this amp can handle and different options to wire your subs such as series or parallel so that your amp is stable when pushing your subs and its not a drain on your battery every time you turn it on.