Getting code f70 & f71 washer will not run water does not fill or spin

Hi.

Please read the article I wrote on fault codes F70 and F71. The problem is the same with all Duet models:

F70 and F71 are two logic board error codes that point at a communication error between the main log...
Regards. Ginko.

Hi,

F71 points at a connection error between button pad and control board.

Please read the indications in this article: F70 and F71 are two logic board error codes...

Regards.

Hi.

Please read the tip below, explaining how to fix F70 and F71 problems. The comment applies to Whirlpool Duet washers like the one in question.

F70 and F71 are two logic board error codes that point at a communication error between the main log...

Regards.

Ginko.

Hi.

Please read the tip below, explaining how to fix F70 and F71 problems. The comment applies to Whirlpool built kenmore washers like the one in question.

F70 and F71 are two logic board error codes that point at a communication error between the main log...

Regards.

Ginko.

Hi.

Sorry for the late reply.

F71 points at a connection error between button pad and control board.

Please read the indications in this article: F70 and F71 are two logic board error codes...

If you get similar problems in the future, and machine gets stuck in error mode with clothes inside, empty water from tub disconnecting the drain filter, located behind a panel in front lower side of appliance. After emptying water the door will normally get opened.

Regards.

Hi.

Please click on the link below and read the indications about errors F70 and F71:

F70 and F71 are two logic board error codes that point at a communication error between the main log

Hi.

Please read the tip below, explaining how to fix F70 and F71 problems. The comment applies to Whirlpool built Maytag washers like the one in question.

F70 and F71 are two logic board error codes that point at a communication error between the main log...

Regards.

Ginko.

Hi.

Please read the tip below, explaining how to fix F70 and F71 problems. The comment applies to Whirlpool built kenmore washers like the one in question.

F70 and F71 are two logic board error codes that point at a communication error between the main log...

Regards.

Ginko.

Hi.

I think that by this time you already fixed the problem. The codes indicate usually a fault that is either CCU or MCU.

Please read the tip below, explaining how to fix F70 and F71 problems. The comment applies to Whirlpool built kenmore washers like the one in question.

F70 and F71 are two logic board error codes that point at a communication error between the main log...

Regards.

Ginko.

Hi.

Please read the tip below, explaining how to fix F70 and F71 problems. The comment applies to Whirlpool built kenmore washers like the one in question.

F70 and F71 are two logic board error codes that point at a communication error between the main log...

Regards.

Ginko.