Freezers Logo

Related Topics:

Question about Hotpoint Freezers

1 Answer

Hi , i have a hotpoint quadrio fridge freezer which has developed a fault which is a design fault...the wire inside the door has been severed by the hinge making it very dangerous, having looked on forums it is apparent that many people are having the same probled,,..are hotpoint liable to repair it?...the unit's around 18 months old

Posted by dazz_hill7 on

1 Answer

Chris Huff

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Hotpoint Master
  • 6,289 Answers

Check with Hotpoint / GE and inform them of your concerns.

Posted on Nov 07, 2017

5 Related Answers

douglas smith

  • 1462 Answers

SOURCE: Fitting a Zanussi fridge thermostat

the stat is clamped to the backplate of the frodge with a simple clamp held just by two screws. undo the clamp. the stat capiliary may be bent back on itself, if so straighten it and it will pull out

Posted on Oct 18, 2008

Anonymous

  • 16 Answers

SOURCE: Hotpoint FFA97 freezer works but fridge does not

It seems to me that there is a leak of gas from your unit.This is if you have 1 compressor/motor)If there is two compressors on unit then it can be thermostat for fridge.Anyhow check if motor is running all the time and is wery hot, if it is there is to little gas in system .This should be covered by guarantee.Jan

Posted on Feb 15, 2009

Anonymous

  • 3 Answers

SOURCE: Fridge/Freezer combo - Freezer working fine but fridge is not

There is a duct between the freezer and refrigerator. Sometimes this duct blocks off with ice and won't allow airflow. Open your refrigerator door and check for air flow if there is none the duct needs to be defrosted. turn off freezer/ refrigerator and defrost.

Posted on Feb 27, 2009

Anonymous

  • 2 Answers

SOURCE: my hotpoint ff187e fridge/freezer keeps bleeping and flashing

Turn the second knob at the top to off (freezer knob) turn the fridge freezer off. Then turn it back on. That may sort it. Or you may need to totally defrost the machine as there could be some ice blocking some vents. May need to remove the back panel of the freezer for this (inside).

Posted on May 09, 2009

Anonymous

  • 1531 Answers

SOURCE: Frost forming on top of inside door by hinge

try covering the hose in the bottom of the door with tape or remove the plugs and glue them shut.also the diffuser plate in the back of the freezer should be changed if you can not change it cover those holes with some aluminum tape.the insulation in the door panel should aslo be replaced there is a chance of ice built up in the door liner

Posted on Sep 17, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

Hotpoint quadrio fridgefreezer keeps tripping the electrics when I open the fridge door.

I believe that a short circuit creates a defective light bulb inside the refrigerator or some other element in its circuit (door switch, lamp socket, wiring).

Dado
0helpful
1answer

Hotpoint FZ175G red warning light comes on freezer still freezing after reset light comes on again after a couple of hours

Red light on for High Freezer Temperature Warning
or freezer not cooling, but fridge is and a lot of noise from compressor.
Also, fridge drain hole blocked, water in bottom of fridge.


This is a common fault in Hotpoint Fridge Freezers and can also happen if the door has been left open or has been a power cut.

1. Turn off fridge freezer, or at least turn down the freezer temp to minimum, though not ideal.
2. Open freezer door and remove all drawers.
3. Remove the back panel on the inside of the freezer. This is held in place with 4 screws, which might be 6mm hex head or star allen head. Pull the panel out.
4. Behind where the panel was, there is a cooling element for cooling, pipes, and below this a temperature sensor. If the fridge freezer is not switched off, then fold together a few layers of tinfoil and wrap around the sensor.
5. Use a hairdryer to slowly melt the ice. Melt it around areas where it appears to be hanging on, such as the corners of the cooling element or bolts, as well as any thin sections below the main block of ice around the cooling element, which will be supporting the main block. Use a plastic ice scraper to remove ice but not near pipes or sensor.
Warning: Be careful using electrics around water & melting ice & drips.
6. Below the cooling element, there is a drip channel & drain hole. If this hole is full of ice, pour a small amound of warm water down, leave for 10 seconds and pour a bit more until clear.
In the fridge, clear the drain hole in the same way.
Warning: Do not pour a lot of water down, as this water drains onto a tray above the hot compressor at the rear of the fridge freezer to be evaporated by the heat of the compressor and the tray will only hold a small amount.
7. When all ice is removed, dry all moisture. Put the shelves back. Close door. Turn on fridge freezer. Turn up the freezer temperature to your normal setting. Turn on fast freeze if available. After 1 hour, check with a thermometer. It should be cold enough after 1 or 2 hours.
Sep 17, 2013 • Freezers
0helpful
1answer

My hotpoint ff187 fridge/freezer is making a beeping sound and has flashing lights. We have tried everything from turning off this button and that, then trying the power off and backwards again. There is...

clean the door rubbers and sides this sometimes fixes the problem as the seals are not closing properly and the fridge freezer thinks you have left the door open.
0helpful
2answers

Freezer not working

Hi,
As the weather is getting warmer for many people their freezer and/or refrigerator do not work right because of a dirty condenser coil...

Check out this tip that I wrote about that... it is a great place to start trouble shooting your unit...and something that you can do rather then calling a repair person to do a simple thing for you...

http://www.fixya.com/support/r4024657-refrigerator_condenser_coil_cleaning

heatman101
Apr 17, 2010 • Freezers
0helpful
1answer

Hello, my hotpoint FF187E fridge freezer keeps tripping my electric off, sometimes it will stay on for a couple of days other times it does this straight away, any idears would be appreciated, thanks...

you may have a burned wiring which when wet trips off you electricity. the location may be in front of your unit between the doors if you have a two door fridge. if you have a singole door unit it may be located on lower area of the fridge body which where the water flow down when you have excess water dripping infront of your fridge. those two location are most likely because the wiring installations from thermostat, heater, and ligth are there. ofcourse you have to check first the compressor and it's auxillaries
Jan 13, 2010 • Freezers
4helpful
1answer

Hotpoint Fridge freezer FFA74 Freezer Door Will not close

check that the part that the drawers slide into is in its proper position. try lifting up on door to shut. if this works u may have a broken cam riser. or u may be able to put a washer or two on hinge to raise door up for better clearance.
4helpful
1answer

Fridge/Freezer combo - Freezer working fine but fridge is not

There is a duct between the freezer and refrigerator. Sometimes this duct blocks off with ice and won't allow airflow. Open your refrigerator door and check for air flow if there is none the duct needs to be defrosted. turn off freezer/ refrigerator and defrost.
0helpful
1answer

Whirlpool 20RB D4 Fridge Freezer clicking

Hi the reason for your noise coming from the fridge freezer is the plastic that is used in the design of your product is of a low quailty which reacts to the temp change and then as they get cold again they start to crack inside the frigde! Nothing to worrry about........
Hope this helps.....
Dec 23, 2008 • Freezers
1helpful
2answers

Fridge freezer

fully defrost it 48 hrs with the doors open and that can often cure it.
Not finding what you are looking for?

505 views

Ask a Question

Usually answered in minutes!

Top Hotpoint Freezers Experts

tina gallow

Level 2 Expert

149 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

57424 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15087 Answers

Are you a Hotpoint Freezer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...