How to use your control with my dvd player - DISH Network IR Remote Control

Chegui59

I have provided instructions on programming your DISH remote to your DVD player.

DVD codes:
http://tech.dishnetwork.com/departmental_content/techportal/content/tech/remotes/TechRemo5.3Code.shtml#dvd

Address To Other Equipment Using Code

• Remotes: Multiple Mode Buttons (TV,VCR, AUX)
  1. Press and hold the desired Mode button until all mode button backlights come on, then release.
  2. Use the number buttons to enter the device code corresponding to the equipment. AUX Mode: Before entering the device code:
     • Press 0 for a TV
     • Press 1 for a VCR/DVD
     • Press 2 for any other device.
  3. Press the pound (#) button Note: The light will blink off after each digit is entered and then return to a steady light.
  4. Press the POUND (#) button. If the code entered is valid for the remote, the mode light flashes three times.

Hello chegui59, my name is Michael Hurst with DISH Network. There are 2 ways of programming your remote to your DVD player. You can use a remote code for your DVD player. In order to give you the right remote code I would need to know the manufacture of your DVD player and the model of the remote that you have. You can also try a Power Scan to get the DVD player programmed into your DISH remote, here are the steps: Withthe desired equipment on, press and hold the correct mode button until all modebutton backlights illuminate, then release. Press and release the Power button. AUX Mode: Before pressingand releasing the Power button. Press 0 for a TV, Press 1 for a VCR/DVD andPress 2 for any other device. Then Press STAR (*). Press the Up button once asecond while pointing the remote at the desired equipment. If the code for theequipment comes up, the equipment will power off. Press the POUND (#) button. Ifthe code entered is valid for the remote, the mode light flashes three times.