51f500 red tint with subtle white diagonal lines

db:: 4.31::Diagonal lines on tm2 screen? fz - Hivmr

www.hivmr.com/db/fzap9jk8dp87mcjk3cc9jsp7fzxk7pz1

There are faint 45 degree diagonal lines covering my brand new tm2 LCD ... with some static looking diagonal lines going from bottom left to top right. .... DB:3.01:Dv6113 Us - Computer Freezes Showing Diagonal Lines On Screen aj ... Also there arediagonal lines that run across the screen at about a 30 degree angle.

3M Privacy Filter for Laptop diagonal-14.1" viewing screen ...

www.amazon.com/3M...diagonal-14.../B00006B8A9

Amazon.com, Inc.
Rating: 3.8 - ‎1,617 reviews
Amazon.com: 3M Privacy Filter for Laptop diagonal-14.1" viewing screen ... Premium 14.0 Inch Privacy Screen for Widescreen Laptop or Computer Monitor .... 3M™ Privacy Filters create a 30-degree cone of vision so on-screen data is .... You'll also notice a large "3M PF14.1W" printed in the top right hand corner of the filter.

FZ190: Faint Diagonal lines on screen? ' NotebookReview

forum.notebookreview.com > ... > VAIO / Sony

the rgb board is faulty

If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience. http://electronicshelponline.blogspot.com/
Line, faults & possible causes to both Plasma &LCD screen are given with illustrations. You can get an idea about the fault to an extent.

not so sure if warped lines about it not being convergence, if the lines are diagonal and light red etc it may be a screen circuit issue. Hard to tell from description----take a few good photos and post them on a free photo sharing site and provide a link here---expert who sees what it looks like may be able to help...............

You need to adjust the red screen control; fairly easy and common on this model.

If you need to know how to do it let me know.

Hello,
If you have RED color that starts from Center of the Screen,(no red color on sides ) 100 % your light engine is deffective..
In order to solve this issue Replace Light Engine Control Board (also called Driver Board ) attached to light engine.

Good Luck

Do not forget to Rate!!

Dals123

it can be a picture tube problem. moreover, check if your tv is dusty inside it . clear it with blower and try again.


regards,

Thats the first stages of the 3 red lights ,the white lines are vertical sheering caused by the vga chip.Microsoft now give 3 years warrenty for the 3 red light error plus if you have only just had it back from Microsoft then it will have deffo got a year on it anyway.

mmmmm

use the advanced options page and reset the factor blue and red convergence defaults then do re apply the auto color defaults color at first it seemed very red (which is good because red was the missing factor in the green picture) but after reseting all the color and tints to the normal ranges I then reset the color auto correct again and all seems fine.