Question about Neovo AG 17" LCD Monitor

1 Answer

I HAVE A NEOVO E-19A MONITOR. ON BOOT UP SCREEN GOES BLANK AFTER ABOUT 5 SECS. TURNING OFF THE MONITOR THEN TURNING BACK ON BRINGS THE SCREEN ON FOR APPROX 5 SECS BEFORE GOING BLANK AGAIN. THIS IS REPEATED WHENEVER POWERED OFF THEN ON MONITOR IS 6 YEARS OLD

Posted by peter_dolliv on

Ad

1 Answer

electronic & computer repair& servicre

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 12,061 Answers

Http://www.devicemanuals.com/guide/LCD/AG%20Neovo/AG-Neovo-S-19A-LCD-Display-English-Owner's-Manual-T1RjMU9Uaz.html
dlc.sun.com/pdf/820-0119-10/820-0119-10.pdf
http://www.scribd.com/doc/3082274/AOC-LCD-Monitor-786LS-Service-Manual
Use these training manuals, to troubleshoot and sort your issue out.
Above is a user manual, and a service manual, in the service manual, are the troubleshooting steps to perform to isolate the problem, and hopefully repair.

Posted on May 25, 2010

  • wwoef May 29, 2011

    I successfully repaired my Neovo E-19A lcd moniter yesterday and it still works after a 24-hr burn-in.
    At the bottom of the inverterboard are two light-brown SMD fuses with "2.0" printed on them (can't miss 'm!). I found one to be open and simply replaced it with a standard glass fuse that I soldered across the SMD with some short wires. To prevent short-circuits I insulated the fuse and wires with tape.
    Many other things can be dead such as the transistors or even the transformers... So, obviously I was lucky! :)

×

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Total white screen with very faint vertical bars


try on another system to see if it is monitor or video board on original system

Jan 20, 2011 | Neovo E-19A 19" LCD Monitor

1 Answer

I got this monitor off of craigslist "because it didn't work". The VGA has never worked, but the DVI worked fine for several months. Recently, the screen goes black, the screen shows a 'no...


Check the VGA output pins on your computer. Install a different monitor and see if it works on your computer. Or it could also be the VGA cable (pins) on the monitor is loose.

Dec 16, 2010 | Neovo E-19A 19" LCD Monitor

1 Answer

AG Neovo Monitor not working


nothing you can reset from monitor other than color brightness. You can contact with AG Neovo as [email protected] to have a RMA number and they will estimate you the repair fee if it is out of warranty.

Jan 06, 2010 | Neovo E-19A 19" LCD Monitor

1 Answer

I NEED THE SERVICE MANUAL FOR AN AG NEOVO E-19A MONITOR.


Good luck on that one...you can only get that if your a service center.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c

Dec 11, 2009 | Neovo E-19A 19" LCD Monitor

1 Answer

Neovo e-19a flat panel will not work with gateway e4000.


You may have to turn on the external video from inside the BIOS; not all systems are set up to feed video to the VGA port unless told to do so.

Oct 26, 2008 | Neovo E-19A 19" LCD Monitor

1 Answer

Blackouts


have you checked your ram

Apr 03, 2008 | Neovo E-19A 19" LCD Monitor

2 Answers

Screens works for 5 mins then goes blank!!!!!


It could also be that the video card is not compatible with this monitor. After the pc boots up, can you get into windows? Does the monitor always go out at a specific time on boot? Say for example; you boot the pc, windows startup splash screen comes on; screen does a quick flash and goes blank. Then it maybe the BIOS setting for the video. Try changing the IRQ setting. You could also try putting the video card in another slot. Do you have the manual for the motherboard? Ray

Jun 20, 2007 | Relisys TL565 15" LCD Monitor

6 Answers

Screen goes black in half a second....


Call the service dept. in the above post. Tell them the model and serial number of your monitor and order a backlight inverter board(approx. $35 plus shipping). Open up the monitor and plug it in, should fix the problem. This problem could also be caused by one or more backlights(small flourescent tubes) being bad. I just fixed a Neovo F-417 display by replacing one of the backlight assemblys. I also just fixed a Neovo E-17DA monitor by replacing the inverter board.

Oct 30, 2006 | Neovo E-19A 19" LCD Monitor

Not finding what you are looking for?
Neovo AG 17" LCD Monitor Logo

1,138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Neovo Computers & Internet Experts

Cindy Wells

Level 3 Expert

6082 Answers

Dimitar Todorov

Level 2 Expert

241 Answers

Leo Stuurman

Level 1 Expert

6 Answers

Are you a Neovo Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...