What does it mean when it doesn't work & it says "fe"?

can you hear the starter click at all take a hammer and tap on the starter if that works then you know the starter is bad, if you are comfortable enough take out the battery and the starter and take them to your local autozone have them tested just because a battery is fully charged doesn't mean that it doesn't have a dead cell or 2. They can test the starter also

Fix your car right away by clicking the link I attached
2005 Hyundai Santa Fe CRTD CDX Workshop Service Repair Manual

The 04 Santa Fe came with three different engines. 4 cylinder (2.4 lit), and two different V6's (2.7 lit & 3.5 lit). The 2.4 & 2.7 use throttle cables connected directly to the throttle plate, but the 3.5 uses ETS (Electronic Throttle System) which uses two sensors (APS & TPS) and a control module (ETSCM). APS=Accelerator Position Sensor, TPS=Throttle Position Sensor, ETSCM= Electronic Throttle System Control Module. There are different diagnostic procedures for each system.
Go to www.hmaservice.com and register your vehicle by VIN #.. you'll then have access to wiring diagrams, shop manuals, service bulletins, campaigns, illustrations and procedures, etc.

Initially I would agree fuel pressure had dropped off after shut down. This fuel filter is a sock screen attached to the fuel inlet tube of the fuel pump and is located inside the fuel tank with the fuel pump. This screen is rarely the cause. You'll need a fuel pump pressure gauge to verify the low fuel pressure at start up. Caution, sometimes this low pressure isn't a faulty pump, sometimes it's a poor wiring connection to the pump motor. An analog amp meter can verify if there is fluctuation/ing current flow to the fuel pump. A fluctuating current flow could mean poor connections, or could mean the pump has/is gone/going bad.

Hi from retired Englishman in SW France,

LG's 'FE' stands for 'overFlow Error' which I strongly suspect means a service engineer's attention. Sorry ;-0(

If this has assisted and/or clarified the situation for you please consider a 4 thumbs up on our rating.
Thanks and good luck!
John C

Maytag Dryer and FE code means power source "Frequency Error".
Invalid power... you will need a electrican to come out the power is not wired up right.

I would replace the wall receptacle before buying any dryer parts
Hope this helps (remember to rate and comment this answer).

I found this information on the internet. I hope that it helps.
" Getting fe code on lg washer.
"This means that the washer is overflowing. This is a built in fault that turns on the drain pump so that the water doesn't get so high that it gets into the floor. If water is continually flowing into the washer you will get this problem. If this is the case the water valve is most likely the problem. To confirm unplug the washer and if the water doesn't stop flowing into the washer the water valve is the problem.

Thank you,
Shawn"

I hope that this helps you out

Hello friend, Please let me know any text came in display or not. If complete dark then its a LCD problem & need to replace it. But tell me before any text message showing or not.

Do you mean P0301, P0302, etc? Misfire codes? You have 6 plugs, 3 coil packs, and 3 wires. cyl 2,4,6 are the ones in front, with the coil packs. It's possible they're bad.

only one speed sensor it is in the back side top of the tranny has a 10mm bolt holding it in about $44