This sounds like the interlock has failed. The door latch connects into a small electronic device inside the machine and if this fails the door will not lock and therefore the machine will not function. To replace this, power off the machine. open up the door seal and inside where the latch goes in you will find the interlock. replace that.
Hello,hi the code will flash that because of the drum being seized in my
opinion the bearings have seized to replace them you will need to
remove the front of the machine disconnect all the wires from the drum
not the machine there are two plastic pegs holding the suspension legs
to the drum which you will need to remove. push the pins in at the
back of the pegs and pull out the pegs,sorry you will need too remove
the two concrete blocks top/bottom first, then remove the pegs lift out
the drum remove the fixings around the drum with a t-30/t-40 bit,then
split the drum now comes the tricky bit - AT THE BACK OF THE DRUM IS A
13MM BOLT UNDO THIS ONE TAKE OFF THE FLY WHEEL AND THEN REPLACE THE
BOLT HIT THIS BOLT AS HARD AND AS CLEANLY AS YOU CAN WITH A LARGE
HAMMER SO THE STAINLESS STEEL DRUM COMES OUT THEN YOU NEED TO GET THE
OLD BEARINGS OUT THESE CAN BE A PIG SOMETIMES SO DONT GIVE UP THEN
REPLACE WITH NEW ONE'S PUT BACK TOGETHER IN REVERSE ORDER.
Thanks
304 views
Usually answered in minutes!
×