What's default password and user name for Actiontec GT704WG

1. Enter your user name. If you didn't change the user name during installation, enter admin in theUser Name field. [Show Me]



2. Enter the password you entered during installation and click OK. Additional characters will appear to be inserted as you enter your password. This is designed to hide the number of characters in your password.


• Note: If you didn't change the default password when you set up your router, it may have been changed to your router's serial number to provide greater security. You can find your router's serial number on a label affixed to the bottom or back of your router.
• Note: If you can't remember your user name or password, you must reset your Verizon MI424WR router to the default settings and reconfigure your home network.

In order to get the wifi WEP key for your network, turn over the bottom of the modem- the default WEP key is on a sticker-
Bar that, on your pc open up a web browser, type in 192.168.1.1 in the address bar- by default the user name and password are admin and password- go to the wireless tab, and basic security settings- the WEP key would be listed there

I’m happy to help further over the phone at https://www.6ya.com/expert/susan_42b401e0b1603d8a

By default the WEP key is on the bottom of the gateway- however to login to the gateway, the user name and password are admin and password

I’m happy to help further over the phone at https://www.6ya.com/expert/susan_42b401e0b1603d8a

user name is admin and password is password

open a browser - clear the address bar - type in
192-168.1.1 - then in the password - forget the username unless u set it - in the password type in 'admin' - just admin that's it -
the go to security - - hunt around and you will see your wep numbers - there will be 4 of them most likely - pick one -
Gary

The default settings are:

Username: admin
Password: password

if this is fresh from the box, the factory default will be (username - admin) and the (password - admin). but if this already configured by the user before, all you have to do is restart it so that it will back into factory default.

simply press the "reset button" for 10 sec...
then try to login as a factory default then configure it again

Username: "admin" and Password:"password", unless you changed it. If you did, just reset the modem to the factory settings by keeping the reset button pressed, and admin and password should work again.

The default username for the router is admin all lower case. The default password, is blank.

Try this first - if that does not work, you will have to set the router back to factory defaults, then do any setups on it that you had before.

To perform a reset on the Actiontec - Press and hold the reset button on the back of the Gateway for 15 seconds. This will reset the unit back to its factory default settings.

Press and hold the reset button on the back of the Router for 15 seconds. This will reset the unit back to its factory default settings.